Hotpoint FA2 840 P IX HA Guide d'utilisation et d'entretien télécharger pdf (Page 17)

1. After removing the door and resting it on a soft

surface with the handle downwards, simultaneously

press the two retaining clips and remove the upper

edge of the door by pulling it towards you.

2. Lift and firmly hold the inner glass with both

hands, remove it and place it on a soft surface before

cleaning it.

3. Refit the intermediate pane (marked with “R1”)

before refitting the inside pane: To position the

panes of glass correctly, make sure that the “R” mark

can be seen in the left-hand corner. First insert the

long side of the glass indicated by “R” into the

support seats, then lower it into position.

Repeat this procedure for both panes of glass.

4. Refit the upper edge: A click will indicate correct

positioning. Make sure the seal is secure before

refitting the door.

CLICK & CLEAN ‑ CLEANING THE GLASS

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23

Pas de commentaire

Hotpoint FA2 840 P IX HA Guide d'utilisation et d'entretien Page 17