Hotpoint OL 1038 LI RFH Mode d'emploi télécharger pdf (Page 13)

2. Choose which shelf

to use with the sliding

rack. Paying attention

to the direction in which

the sliding rack is to be

extracted, position joint

B and then joint C on

the frame.

3. Secure the two

frames with the guide

rails using the holes

provided on the oven

walls (see diagram).

The holes for the left

frame are situated at

the top, while the holes

for the right frame are at

the bottom.

4. Finally, fit the frames

on the spacers A.

! Do not place the sliding racks in position 5.

Side and rear catalytic liners*

These are panels coated with a special enamel,

which is able to absorb the fat released by food as it

cooks.

This enamel is quite strong, so that the various

accessories (racks, dripping pans, etc.) can slide

along them without damaging them. White marks

may appear on the surfaces; these are not a cause

for concern.

Nevertheless, the following should be avoided:

- scraping the enamel with sharp objects (a knife, for

example);

- using detergents or abrasive materials.

Left

guide rail

Right guide

rail

Direction

of extraction

Only available in certain models.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Pas de commentaire

Hotpoint OL 1038 LI RFH Mode d'emploi Page 13