Hotpoint S230G DY230G Manuel d'utilisateur télécharger pdf (Page 25)

CARE AND CLEANING

Take particular care not to damage the inner surface of the door inner glass that

is coated with a heat reflective layer. Do not use scouring pads, or abrasive

powder, which will scratch the glass. Ensure that the glass panel is not subjected

to any sharp mechanical blows.

Stubborn stains can be removed by using a fine steel wool pad.

For slight soiling the

inner glass panel may be cleaned, while still warm, without removing it from the door.

After cleaning, rinse and dry with a soft cloth.

CLEANING THE DOORS

SIDE OPENING DOORS

Cleaning the door glass is the same as the drop down doors, except take care to

support the weight of the inner glass when removing and refitting.

DROP DOWN DOORS

Remove the door inner glass as follows.

1. Open the door fully and unscrew the two screws securing the glass panel so that

the securing brackets can be turned. There is no need to remove the screws

completely.

2. Turn the brackets so that the glass can be

removed and cleaned at the sink (Fig. 1.)

3. The inside of the outer door glass can now be cleaned while still fitted to the

cooker.

NEVER OPERATE THE COOKER WITHOUT THE INNER DOOR GLASS

IN POSITION.

Refit the door inner glass as follows.

1. NOTE: The inner door glass has a special reflective coating on one side. Replace

the door inner glass so that the statement: “IMPORTANT THIS FACE TOWARDS

THE OVEN” can be read from the inner side of the door.

2. Turn the two securing brackets back to their

original position to retain the glass and tighten

the screws. (Fig. 2.)

Fig. 1.

Fig. 2.

Glass

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Pas de commentaire

Hotpoint S230G DY230G Manuel d'utilisateur Page 25