Hotpoint SX 638 CK Mode d'emploi télécharger pdf (Page 4)

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

APPLIANCE SPECIFICATIONS

Dimensions

width 43.5 cm

height 32 cm

depth 41.5 cm

Volume

58 l

Electrical

connections

Voltage at 220-240 V~ 50/60 Hz or

50 Hz (see data plate)

maximum power absorbed 2800 W

ENERGY

LABEL

Directive 2002/40/EEC on the

label of electric ovens.

Standard EN 50304

Energy consumption for Natural

convection – heating mode:

Traditional mode

Declared energy consumption

Forced convection class -

heating mode:

Baking.

This appliance conforms to the

following EEC Directives:

2006/95/EEC dated 12/12/06

(Low Voltage) and subsequent

amendments - 2004/108/EEC

dated 15/12/04 (Electromagnetic

Compatibility) and subsequent

amendments - 93/68/EEC dated

22/07/93 and subsequent

amendments. 2002/96/EEC

and subsequent amendments.

Electrical connection

The electrical connection to the mains must be made

on the appliance. The power voltage and frequency

are as indicated on the rating plate.

THIS APPLIANCE MUST BE EARTHED.THIS APPLIANCE MUST BE EARTHED.

THIS APPLIANCE MUST BE EARTHED.

Connecting the power supply cable

To open the terminal board:

• Using a screwdriver, press on the tabs situated on

each side of the terminal board cover.

• Pull open the terminal board cover.

To connect the power supply cable, proceed as

follows:

••

• Unscrew the cable clamp screw and the contact

screws L-N-.

• Fasten the wires beneath the screwheads using the

following colour scheme: Blue (N) Brown (L)

Yellow-Green



• Fasten the power supply cable in the corresponding

cable clamp and close the cover.

Electrical Connection:

Voltage Frequency: 230

V-1+N 50Hz

Fuse Section: 16A

Supply cable: 3x1.5mm

You can connect your oven to the system means of a

terminal board. Refer to above information for the

minimal cable sections and the calibration of the

protective elements according to the connection.

If the appliance is installed with a junction box, an

omnipolar circuit breaker - with a minimum contact

opening of 3mm - should be installed between the

appliance and the mains.

Power cable supply connection to the electrical

mains:

We recommend you use a power supply cable which

is long enough to allow you to take the oven out of its

recess in the event of maintenance operations (only

use HAR - H 05 - RRF quality cables fitted with a plug

conforming to the regulations in force.

The plug must be accessible at all times.

Unplug the appliance before all operations, even

when replacing the oven lamp.

Using the appliance without correct earthing is

highly dangerous.

! After connecting the appliance to the flexible

cable, tighten all the screws on the terminal

board.

1 2 3 4 5 6 7 8 9 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

Hotpoint SX 638 CK Mode d'emploi Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Fours Hotpoint SX 638 CK