Hotpoint GE 230 AI Mode d'emploi télécharger pdf (Page 14)

Caring for Your Appliance

Before doing any cleaning, disconnect the appliance

from the electricity (by pulling out the plug or turning

off the general switch in your home).

Defrosting

WARNING: do not damage the refrigeration circuit.

Do not use mechanical devices or other tools to speed

up the defrosting process, unless they have been rec-

ommended by the manufacturer.

The evaporator defrosts automatically during operation; the

defrost water drips into the drain, is collected in a special

tray and then evaporates.

Clean the defrost water drain hole periodically (see fig. 1) to

prevent water from collecting on the bottom of the refrig-

erator instead of flowing out.

Fig. 1

Cleaning and Maintenance

- Your appliance is manufactured with hygienic, odourless

materials. To preserve these characteristics, always use sealed

containers to store foods in order to prevent spills, stains

and the formation of difficult to remove odours.

- Only use a water and bicarbonate solution to clean the

applianc. Clean the internal and exterior of your appliance

with a sponge soaked in a warm water and sodium bicarbo-

nate solution, which is also a good disinfectant. If you do

not have any sodium bicarbonate at home, use a neutral

soap.

- What not to use: Do not use abrasive detergents, bleach

or detergents containing ammonia. Never use solvent based

products.

- All removable parts can be cleaned by soaking them in hot

soapy water or detergent. Remember to dry them thoroughly

before replacing them.

- Discontinued use of the appliance: If the appliance is not in

use for any length of time, remember to clean the interior

and dry thoroughly, leaving the door open to prevent the

formation of odours and mould.

- Replacing the light bulb. The bulb for lighting the interior

of the appliance is located at the back of the thermostat

box. Unscrew the burned out bulb and replace it with an-

other bulb with a wattage no higher than 15 Watt, follow

the instructions illustrated in fig. 2.

Before carrying out this operation, disconnect the appli-

ance from the electricity (to do so, turn off the general switch

in the house or remove the plug for the appliance from the

socket).

Fig. 2

1 2 ... 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Hotpoint GE 230 AI Mode d'emploi Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Non Hotpoint GE 230 AI