Hotpoint LPR 827 Mode d'emploi télécharger pdf (Page 2)

INSTALLATION

Technical information for the installer

• The oven has been designed to be installed under a worktop surface.

• Do not lift the oven by the handle, but hold it by the sides.

• Make sure that the appliance was not damaged during transport.

• The oven and unit dimensions are shown in the below figures.

• The units in contact with the oven must be heat-resistant (min. 85°C).

• If the plastic laminates or the sealing material are not sufficiently heat resistant, this may result in the formation of

bubbles, deformation of the surface or detachment of the coating.

• Insert the oven in the unit cavity, lifting it by the sides and being careful not to trap the power cable.

• The oven and housing dimensions are illustrated in the below figures.

• For correct ventilation, follow the ventilation opening directions shown in the figure 1.

• Two systems can be used to fit your appliance to a chosen furniture layout:

A. Between two side panels of two distinct cabinet units without the aid of a support shelf, by fitting four support

steel brackets provided with the product. (fig. 3).

B. Between two side panels each fixed to the side of a cabinet unit without the aid of a support shelf. In this case only

the two lower support brackets will be necessary (fig. 4).

Note: In both of the above cases you must measure 717 mm from the underside of the worktop and mark the correct

position of the lower support brackets before fixing them to the sides. With reference to (fig. 3), ensure the side

support brackets are positioned 40 mm from the front of the cabinet door exterior surface, as illustrated, before

securing them to the cabinet sides. If necessary, this product can be installed in a housing unit (fig. 2). The housing unit

will not be a standard one but will have to be of a size that can accommodate the full height of the oven - minimum

height 717 mm. This housing unit will need to fulfil the ventilation requirements.

• Fasten the oven using the screws.

NOTE:

Always remove

the rear panel

of the housing

unit

Top

Oven

Front of

oven

Rear

Wall

Important

BACK EDGE OF SUPPORT

SHELF (WHEN APPLICABLE)

Fig. 1 Fig. 2

Fig. 3 Fig. 4

717

665

708

715

717

715

665

708

717

665

708

715

6gb66028a.fm Page 4 Friday, August 20, 2004 10:51 AM

1 2 3 4 5 6

Commentaires sur ces manuels

Pas de commentaire

Hotpoint LPR 827 Mode d'emploi Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Non Hotpoint LPR 827