Hotpoint SI7 871 SC IX Guide de l'utilisateur télécharger pdf (Page 11)

REMOVING AND REFITTING THE DOOR

1. To remove the door, open it fully and lower the

catches until they are in the unlock position.

2. Close the door as much as you can.

Take a firm hold of the door with both hands – do not

hold it by the handle.

Simply remove the door by continuing to close it

while pulling it upwards at the same time until it is

released from its seating. Put the door to one side,

resting it on a soft surface.

~15°

3. Refit the door by moving it towards the oven,

aligning the hooks of the hinges with their seating

and securing the upper part onto its seating.

4. Lower the door and then open it fully.

Lower the catches into their original position: Make

sure that you lower them down completely.

Apply gentle pressure to check that the catches are in

the correct position.

“CLICK”

5. Try closing the door and check to make sure that it

lines up with the control panel. If it does not, repeat

the steps above: The door could become damaged if

it does not work properly.

TROUBLESHOOTING

WWW

Problem Possible cause Solution

The oven is not working. Power cut.

Disconnection from the

mains.

Check for the presence of mains electrical

power and whether the oven is connected

to the electricity supply.

Turn off the oven and restart it to see if the

fault persists.

The display shows the letter “F”

followed by a number or letter.

Software problem. Contact you nearest Client After-sales

Service Centre and state the number

following the letter “F”.

Download the Use and Care Guide from

www.hotpoint.eu for more information

1 2 ... 6 7 8 9 10 11 12

Pas de commentaire

Hotpoint SI7 871 SC IX Guide de l'utilisateur Page 11