Hotpoint Aquarius Range WMS39 Manuel d'utilisateur télécharger pdf (Page 20)

Troubleshooting...

The machine will not start...

●

Close the door. Check that the machine

has power. Choose a programme and

press the ‘START’ button. If after two

seconds the ‘Door Locked’ indicator light

is not lit, check to see:

i) If the machine is plugged in and

switched ‘ON’.

ii) If the socket is OK. Try another

appliance in the socket to check.

iii) If the fuse in the machine plug is

OK. If not, replace it, see ‘Connect

your machine to the electrical

supply’ (see section: INSTALLING

YOUR MACHINE).

The ‘Door Locked’ indicator is flashing...

●

Shut the door firmly, until it clicks.

The ‘Door Locked’indicator light

should now stay on.

The ‘Pre-wash’ progress indicator is

flashing...

●

This means that the machine cannot fill.

Check that the water supply is turned on

and that the inlet hoses are not kinked.

The ‘Wash’ progress indicator is flashing...

●

The wash dial has been moved since the

programme started. Move the wash dial

to the original programme.

The ‘Spin’ progress indicator is flashing...

●

This means that there has been an

unbalanced load and the machine could

not spin:

Open the door, re-distribute the clothes,

close the door and select a spin only

programme.

The programme takes a long time...

●

Some programmes do take a long

time. Things which can lengthen the

programme time include low

temperature and low pressure of the

incoming hot water supply, or low cold

water pressure.

The door will not open...

●

Has the programme finished? Is the ‘End’

progress light lit? The door will not open

until the ‘Door Locked’ indicator light has

gone out. The ‘Door Locked’ indicator

light will go out about two minutes after

the programme has finished.

●

There is still water in the machine.

Go through all the points in the next

section,‘The machine will not pump

out water...’

The machine will not pump out the

water...

●

Make sure that there is no blockage in

the drain hose and that it is not

kinked.

●

Is the drain hose installed correctly?

●

If you have connected your machine to a

sink waste system, make sure that you

have cut out the membrane from the

under sink drainage system.

(see section: INSTALLING YOUR

MACHINE).

●

Ensure that the drainage system,

standpipe or under sink connection is

free from any blockage.

- If any of the above are found to be

the cause of your problem you will

need to run the machine through a

spin only programme.

●

If you have chosen ‘Rinse Hold’, the

light will flash until you press the

‘Rinse Hold’ button to continue the

programme.

The machine is leaking...

●

Check the fill hoses have been

tightened at both ends? If not, tighten

them.

●

Are the fill hoses tightly fitted yet still

leaking? If so, replace the rubber

washers.

●

Is the standpipe or household drain

blocked? You will need to call a plumber

if you cannot clear the blockage.

continued...

20

In the unlikely event that you have problems with your machine, the following guide

may help you to get your machine working correctly straight away. ..

TROUBLE

SHOOTING

1 2 ... 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire