Hotpoint WM51 Manuel d'utilisateur télécharger pdf (Page 2)

WARNING: This appliance must be earthed.

Fuses

Your appliance comes fitted with a plug and a 13A fuse. If you need to replace the fuse, only

those rated at 13A and ASTA approved to BS1362 should be used.To change fuse, lift holder to

vertical position and lift fuse out. To replace, insert fuse and push fuse holder down into locked

position. Correct replacement is identified by colour coding or the marking on base of plug.

WARNING: Do not use plug unless fuse holder is in locked position.

Changing the Plug

Cut off and dispose of the supplied plug if it does not fit your socket.

WARNING: To avoid a shock hazard do not insert the discarded plug into a socket

anywhere else.

IMPORTANT:WIRES IN THE MAINS LEAD ARE

COLOURED IN ACCORDANCE WITH THE

FOLLOWING CODE:

Green/Yellow - Earth

Blue - Neutral

Brown - Live

If you change the plug, the colour of wires

in the mains lead may not

correspond with the colour of the

markings identifying terminals in the plug.

You should therefore wire it as shown

(Fig 1).

Changing the Mains Lead

A special lead can be ordered form Hotpoint Service UK: 08709 066 066 or

Republic of Ireland: 1850 302 200

If you have damaged the existing lead or require a longer one a charge will be made. It is

strongly advised that this work is carried out by a qualified electrician.

CE marking certifies that this appliance conforms to the following EEC directives:-

Low Voltage Equipment - 72/23/EEC & 93/68 EEC

Electromagnetic Compatibility - 89/336/EEC, 92/31/EEC & 93/68/EEC

Electricity Supply

Green and yellow (Earth)

wire to terminal

marked ‘E’,

symbol , or

coloured green

and yellow.

Blue (Neutral)

wire to terminal

marked ‘N’ or

coloured black.

13A ASTA approved

fuse to BS1362.

Brown (Live)

wire to terminal

marked ‘L’ or

coloured red.

Cord clamp

Fig 1

1 2 3 4 5 6 7 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Hotpoint WM51 Manuel d'utilisateur Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Rondelles Hotpoint WM51