Hotpoint WM82 Manuel d'utilisateur télécharger pdf (Page 6)

3. Connect to the Water Supply...

●

Incoming hot and cold water pressure should be between 3 and 150 psi (21 - 1034 Kpa).

●

The temperature of the incoming household hot water supply should ideally be 60°C and no

higher than 70°C as this could cause damage to both your laundry and appliance.

●

The water supply taps must be easily accessible when the appliance is installed.

●

The appliance must be connected to the appliance water supply using the new hose set

supplied, old hose sets should not be used.

Fig 2

Fig 1

Fig. 4

Inlet to machinet

Inlet to machine

Cold Water Supply

Fig. 3

WARNING

●

Do not connect

appliance to a single

outlet instantaneous

water heater.

Hot and Cold Fill

1. Connect straight end of supplied red or grey hose to the

HOT water supply tap (Fig 1). Connect straight end of

supplied blue hose to the COLD water supply tap.

2. Hand tighten connectors sufficiently to ensure water does

not leak from the hose connections.

3. Before connecting each of the hoses to the appliance,

confirm water supply is flowing by holding the free end of

each hose in a bucket, turn the relevant water supply taps

on and then off.

4. Connect angled end of red or grey hose to white plastic

inlet valve marked ‘H’ (Fig 2) and angled end of blue hose

to white plastic inlet valve marked ‘C’ at the back of the

appliance.

5. Hand tighten connectors sufficiently to ensure water does

not leak from the hose connections.

6. Turn on water supply taps and check for leaks from the

connectors. In the event of a leak, turn off supply tap,

remove connector and check sealing washer is in place.

Refit connector and tighten.Turn on water supply taps.

If you have no hot water supply...

A Cold Fill Adaptor (Fig 3) is available from your local Hotpoint

authorised Service Centre or by calling the Genuine Parts &

Accessories Mail Order Hotline UK: 08709 077 077 or Republic of

Ireland: (01) 842 6836.

Fitting a Cold Fill Adaptor

1. Connect straight ends of supplied hoses to the Cold Fill

Adaptor (Fig 3).

2. Connect adaptor to the cold water supply tap (Fig 4).

3. Before connecting the hoses to the appliance hold the

free end of each hose in a bucket, gently turn on the tap

to confirm the water supply is flowing.Turn off the tap.

4. Connect angled end of the supplied hoses to white plastic

inlet valves marked ‘H’ and ‘C’ at the back of the appliance.

5. Hand tighten the connectors sufficiently to ensure water

does not leak from the hose connections.Turn on water

supply taps.

Remember you may be

charged for a service call if a

problem with your appliance is

caused by incorrect

installation or misuse.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Hotpoint WM82 Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Rondelles Hotpoint WM82