Hotpoint BHWD 129 (UK)/1 Mode d'emploi télécharger pdf (Page 6)

Instructions for the fitter

Mounting the wooden panel onto the door and inserting

the machine into cabinets:

In the case where the machine must be shipped for final

installation after the wooden panel has been mounted, we

suggest leaving it in its original packaging. The packaging

was designed to make it possible to mount the wooden

panel onto the machine without removing it completely

(see figures below).

The wooden panel that covers the face of the machine

must not be less than 18 mm in thickness and can be hin-

ged on either the right or left. For the sake of practicality

when using the machine, we recommend that the panel

be hinged on the same side as the door for the machine

itself - the left.

Tur seite

Door Mounting Accessories (Fig. 1-2-3-4-5).

Fig. 1

N° 2 Hinges

N° 1 Magnet N° 1 Magnet plate

N° 1 Rubber plug

N° 2 Hinge Supports

Fig. 2

Fig. 3 Fig. 4

Fig. 5

Fig. 4/B

- No. 6 type A self-threading screws, l =13 mm.

- No. 2 type B metric, countersunk screws, l =25; for fa-

stening the magnet plate to the cabinet.

- No. 4 type C metric screws, l =15 mm; for mounting the

hinge supports to the cabinet.

- No. 4 type D metric screws, l =7 mm; for mounting the

hinges on the supports.

Mounting the Parts onto the Face of the Machine.

- Fit the hinge supports to the appliance front panel, posi-

tioning the hole marked with an arrow in fig. 1 so that it is

on the inner side of the front panel. Fit a spacer (fig. 4/B)

between the surfaces using type C screws.

- Fit the magnet plate at the top of the opposite side,

using type B screws to fix two spacers (fig. 4/B) between

the plate and the surface.

N° 4 Spacers

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Pas de commentaire

Hotpoint BHWD 129 (UK)/1 Mode d'emploi Page 6