Hotpoint WDUD 9640K UK Mode d'emploi télécharger pdf (Page 6)

6

GB

Care and maintenance

Cutting off the water and electri-

city supplies

• Turn off the water tap after every wash cycle.

This will limit wear on the hydraulic system inside

the washer-dryer and help to prevent leaks.

• Unplug the washer-dryer when cleaning it and

during all maintenance work.

Cleaning the washer-dryer

• The outer pa rt s and rubber com-

ponents of the appliance can be cleaned

using a soft cloth soaked in lukewarm so-

apy water. Do not use solvents or abrasives.

• The washer-dryer has a “Auto Clean” pro-

gramme for its internal parts that must be run

with no load in the drum.

For maximum performance you may want to

use either the detergent (i.e. a quantity 10% the

quantity specified for lightly-soiled garments)

or special additives to clean the washer-dryer.

We recommend running a cleaning programme

every 40 wash cycles.

To start the programme

press buttons A and

B simultaneously for 5

seconds (see figure).

The programme will

start automatically and

will last approximately

70 minutes. To stop the

cycle press the START/

PAUSE button.

Cleaning the detergent dispenser

drawer

Remove the dispenser by raising it and pulling

it out (see figure).

Wash it under running water; this operation

should be repeated frequently.

Caring for the door and drum of

your appliance

• Always leave the porthole door ajar in order

to prevent unpleasant odours from forming.

Cleaning the pump

The washer-dryer is fitted with a self-cleaning

pump which does not require any maintenan-

ce. Sometimes, small items (such as coins or

buttons) may fall into the pre-chamber which

protects the pump, situated in its bottom part.

! Make sure the wash cycle has finished and

unplug the appliance.

To access the pre-chamber:

1. using a screwdri-

ver, remove the

cover panel on the

lower front part of the

washer-dryer (see

figure);

2. unscrew the lid

by rotating it anti-

clockwise (see figu-

re): a little water may

trickle out. This is

perfectly normal;

3. clean the inside thoroughly;

4. screw the lid back on;

5. reposition the panel, making sure the hooks

are securely in place before you push it onto

the appliance.

Checking the water inlet hose

Check the inlet hose at least once a year. If

there are any cracks, it should be replaced

immediately: during the wash cycles, water

pressure is very strong and a cracked hose

could easily split open.

! Never use second-hand hoses.

1

2

BA

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Commentaires sur ces manuels

Pas de commentaire