Hotpoint HCM60 Manuel d'utilisateur télécharger pdf (Page 10)



AMC-3

2. Fix the 4 brackets A to the 4 corners of the cabinet opening, using the appropriate screws (Fig. 3).

The horizontal movement of the nut allows any width tolerance of the cabinet to be offset.

3. Fix the 2 angular brackets B to the machine (Fig. 3). The 2 vertical holes on the brackets allow the height of the machine

to be levelled and aligned.

4. Connect the machine to the electricity supply, observing the current safety regulations.

Important : The current plug must be reachable after the installation of the machine.

5. Place the machine in the centre of the cabinet, taking care that the horizontal side of the 2 angular brackets B are slotted

into the appropriate holes on the brackets A (Fig. 3).

6. Open the machine by lifting the handle and pulling outwards, taking care not to pull it out of the cabinet (Fig. 4).

7. Secure the machine using the appropriate screws C (Fig. 4).

8. Close the machine.

The manufacturer declines any responsibility for persons or property and for the incorrect operation of the machine

if the above instructions are not observed in full.

Fig. 3

INSTALLATION OF THE MACHINE

ON/OFF

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Pas de commentaire

Hotpoint HCM60 Manuel d'utilisateur Page 10