Hotpoint RGB747GER Manuel d'utilisateur télécharger pdf (Page 38)

INSTALLATION INSTRUCTIONS

ELECTRICAL CONNECTIONS

(continued)

❑

Usage

Satiations where Appliance

Power

Cord will be Disconnected Frequently.

Do not use an adapter plug in these situations

because disconnecting of the power cord places

undue strain on the adapter and leads to eventual

failure of the adapter ground terminal. The customer

should have the two-prong wall receptacle replaced

with a three-prong (grounding) receptacle by a

qualified electrician before using the appliance.

The installation of appliances designed for

mobile home installation must conform with the

Manufactured Home Construction and Safety

Standard, Title 24

CFR,

Part 3280 (formerly the

Federal Standard for Mobile Home Construction

and Safety, Title 24, HUD, Part 280) or, when

such standard is not applicable, the Standard for

Manufactured Home Installations, latest edition

(Manufactured Home Sites, Communities and

Set-Ups), ANSI

A225.1,

latest edition, or with

local codes. In Canada, mobile home installation

must be in accordance with the current

CAN/CSA Z240/MH Mobile Home Installation

Code.

Electric Disconnect

Locate disconne

plug on the range b

2. Pinch sides of

connector and pull

out of range back.

❑

SEAL THE OPENINGS

Seal any openings in the wall behind the range

and in the floor under the range when hookups

are completed.

❑

CHECK SURFACE BURNER

IGNITION

Operation of all cooktop and oven burners should

be checked after range and gas supply lines have

been carefully checked for leaks.

Push in one of the surface burner controls and

turn it to the

LITJ3

position. You will hear a

snapping sound indicating proper operation of

the spark module. Once the air has been purged

from the supply lines, burner should light within

4 seconds. After burner lights, rotate knob out of

the LITE position. Try each burner in succession

until all burners have been checked.

Quality of Flames

The combustion quality of burner flames needs

to be determined visually.

If burner flames look like (A), call for service.

Normal burner flames should look like (B) or

(C), depending on the type of gas you use.

With LP gas, some yellow tipping on outer

cones is normal.

(A) Yellow

flames—

Call for service

(B) Yellow tips on

outer

cones—

Normal for LP gas

Normal for natural gas

❑

CHECK IGNITION OF OVEN

BURNER

The

oven is

designed to operate quietly and

automatically. To operate the oven, press the

BAKE pad and then press the INCREASE pad

until “350°” appears in the display. After 30-90

seconds, the oven burner will ignite and burn

until the set temperature is reached. The oven

burner will continue to cycle on and off as

necessary to maintain the oven at the temperature

indicated by the display.

To check ignition of the broil burner, press the

BROIL pad and then the INCREASE or DECREASE

pad. After 30-90 seconds, the broil burner will ignite.

The oven requires electrical power to operate. In

the case of a power outage, the oven burners on

these models cannot be lit manually with a match.

Gas will not flow unless the glow bar is hot.

If the oven is in use when a power outage occurs,

the oven burner shuts off and cannot be

re-lit

until power is restored.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Hotpoint RGB747GER Manuel d'utilisateur Page 38

Commentaires sur ces manuels

Produits connexes et manuels pour Cuisiniers Hotpoint RGB747GER