Hotpoint RGB747GER Manuel d'utilisateur télécharger pdf (Page 42)

INSTALLATION INSTRUCTIONS

(continued)

HOW TO CONVERT THE RANGE FOR USE

WITH 1P GAS OR NATURAL GAS

(continued)

❑

CONVERTING SURFACE BURNERS

Burner Cap

1. Remove grates, burner caps and burner heads.

2. Remove burner bases by unscrewing the 3

small screws in each base. Lift

burner

straight out.

DO NOT

disconnect the wires from the burner

bases unless the cooktop needs to be raised.

3. Remove the brass orifice spud under each

burner base by unscrewing spud from fitting with

a 7mm or 5/16” wrench (depending on the size of

your spuds). Apply a 3/4” wrench to the hex on

the gas inlet tube as a back-up when removing

spud to prevent the aluminum tube from twisting.

4. Install orifice spuds according to one of the

following diagrams (see

❑

), for LP gas

or natural gas, depending on which you are

converting to.

❑

Orifice Spuds for Convetiingto

LPGas:

LP orifice spuds are in a small plastic bag packed

with this Use and Care book. LP orifice spuds

have a 2-digit number and the Letter “L” on

one side. Each orifice spud will also have 1 or 2

grooves on one side, denoting the location on

the range where it is to be installed.

❑ Orifice Spuds for Converting to

Naturul

Gas:

Natural gas orifice spuds have a 3-digit number

on one side. Each orifice spud will also have 1, 2

or 3 grooves on one side, denoting the location

on the range where it is to be installed.

Front of Range

—

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 48

Commentaires sur ces manuels

Pas de commentaire

Hotpoint RGB747GER Manuel d'utilisateur Page 42

Commentaires sur ces manuels

Produits connexes et manuels pour Cuisiniers Hotpoint RGB747GER