Hotpoint DF55 Manuel d'utilisateur télécharger pdf (Page 12)

Before Using your Appliance...

12

Before using your Dishwasher you must carry

out the following steps to ensure you obtain

the best possible wash performance from

your appliance.

Follow these 4 steps:

- Adjust the Water Softener.

- Fill the Salt Container.

- Fill the Rinse Aid Container.

- Add detergent.

ADJUSTING THE WATER SOFTENER...

The dishwasher is equipped with a device for

the user to adjust the water softening system,

according to the hardness of the water supply.

The adjustment selector can be found inside

the plastic locking ring located on right hand

interior wall. This allows adjustment to 5

settings:

● In order to rinse dishes and glasses

satisfactorily, the dishwasher requires

soft water i.e containing little or no

lime, otherwise water stains are left

behind on crockery and glasses etc. If

the tap water exceeds a certain level of

hardness, it must be softened, ie.

decalcified, so that it can be used in the

dishwasher.

● The dishwasher is equipped with an

automatic softening system which uses

a special regenerating salt to reduce the

hardness of the water. The dishwasher is

factory set for water hardness level 3

(average hardness 41-60˚dF - 24-31˚dH).

● In order to ensure that the correct

amount of salt is being used to

regenerate the water softener, the

dishwasher is equipped with an

electronic device for adjusting the water

softening setting.The setting may be

adjusted electronically. To set this

correctly the hardness of your water

needs to be ascertained.

WATER HARDNESS TABLE:

● Contact your local water board for

information on the water hardness for

your area.

When using water of medium hardness, the

regenerating salt container should be

refilled after approximately 20 wash cycles.

The salt container can hold approximately

1.7Kg of salt in grains.

SETTING WATER HARDNESS

N. 1 NO SALT 0 - 4˚dH (0 - 7˚dF)

N. 1 5 - 9˚dH (8 - 15˚dF)

N. 2 10 - 22˚dH (16 - 37˚dF)

N. 3 23 - 29˚dH (38 - 50˚dF)

N. 4 30 - 35˚dH (51 - 60˚dF)

N. 5 36 - 41˚dH (61 - 70˚dF)

adjustment selector

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Commentaires sur ces manuels

Pas de commentaire