Hotpoint LFB 4S116 X TK Mode d'emploi télécharger pdf (Page 26)

Care and maintenance

Shutting off the water and electricity

supplies

• Turnoffthewatertapaftereverywashcycletoavoidleaks.

• Always unplug the appliance when cleaningit and when

performing maintenance work.

Cleaning the dishwasher

• Theexternalsurfacesofthemachineandthecontrolpanel

can be cleaned using a non-abrasive cloth which has been

dampened with water. Do not use solvents or abrasive

products.

• Anymarksontheinsideoftheappliancemayberemoved

using a cloth dampened with water and a little vinegar.

Preventing unpleasant odours

• Alwayskeepthedooroftheapplianceajarinordertoavoid

moisture from forming and being trapped inside the machine.

• Cleanthesealsaroundthedooranddetergentdispensers

regularly using a damp sponge. This will avoid food becoming

trapped in the seals, which is the main cause behind the

formation of unpleasant odours.

Cleaning the spray arms

Food residue may become encrusted onto the sprayer arms

and block the holes used to spray the water. It is therefore

recommended that you check the arms from time to time and

clean them with a small non-metallic brush.

The two spray arms may both be removed.

To remove the upper spray arm,

turn the plastic locking ring in an

anti-clockwise direction. The upper

sprayer arm should be replaced so

that the side with the greater number

of holes is facing upwards.

The lower spray arm can be

removed by pressing on the side

tabs and pulling it upwards.

Cleaning the water inlet hose*

Ifthewaterhosesareneworhavenotbeenusedforanextended

period of time, let the water run to make sure it is clear and free

of impurities before performing the necessary connections. If this

precaution is not taken, the water inlet could become blocked

and damage the dishwasher.

Clean the water inlet filter at the tap outlet regularly.

- Turn off the water tap.

- Unscrew the end of the water inlet hose, remove the filter and

clean it carefully under running water.

-Re-placethefilterandscrewthewaterhosebackintoposition.

Cleaning the filters

The filter assembly consists of three filters which remove food

residues from the washing water and then recirculate the water.

They must be cleaned if you wish to achieve the best results in

every wash.

Clean the filters regularly.

The dishwasher must not be used without filters or if the filter

is loose.

•Afterseveralwashes,checkthefilterassemblyandifnecessary

clean it thoroughly under running water, using a non-metallic

brush and following the instructions below:

1. Turn the cylindrical filter C in an anti-clockwise direction and

pull it out

(fig.1).

2.RemovethecupfilterBbyexertingaslightpressureonthe

side flaps

(fig.2);

3.Slideoutthestainless-steelplatefilterA.

(fig.3).

4. Inspect the trap and remove any food residues. NEVER

REMOVE the wash-cycle pump protection

(blackdetail)(fig.4).

Aftercleaningthefilters,re-placethefilterassemblyandfixit

in position correctly; this is essential for maintaining the efficient

operation of the dishwasher.

Leaving the machine unused for extended

periods

• Disconnecttheappliancefromtheelectricitysupplyandshut

off the water tap.

• Leavethedooroftheapplianceajar.

• Whenyoureturn,runawashcyclewhenthedishwasheris

empty.

* Only available in selected models.

1 2 ... 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire

Hotpoint LFB 4S116 X TK Mode d'emploi Page 26

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle Hotpoint LFB 4S116 X TK