Hotpoint TDL52 Manuel d'utilisateur télécharger pdf (Page 16)

The Controls - TDL54 and TVM55 (continued)

(ii) Easy Iron

Cycle

(iii) Timed

Drying

(iv) Cool Tumble

Phase

Auto dry Light

Drying Light

Heat Selection

Alarm (Buzzer)

Selection

This is a short programme of approximately 10 minutes to condition previously

dried clothes. See section ‘Easy Iron Programme’.

It consists of a period of heating followed by a short cool tumble period (as

detailed below).

Select HIGH heat for this programme.

It should not be used on damp loads, as it is NOT a drying programme.

To set the required time, all you have to do is turn the Timer Control

clockwise until the required time appears in line with the indicator.

Never turn the Timer Control anti-clockwise.

The chart in the section ‘Guide to Drying Times’ will tell you how much time

you will need for various loads.

This programme is particularly useful in cases where a damp load is required

for ironing or LOW heat drying is required and also for small loads.

About 10 minutes before the programme is completed, the heating elements

are switched off, and the programme enters the final ‘Cool Tumble’ phase.

During this phase, the fabric is cooled. You should always allow the dryer to

complete this phase.

By opening the door, the dryer will stop and you can check the dryness of the

load as often as you wish and if you want to remove (or add) some items

before they are fully dry. (This is particularly useful for a mixed load where

you want to Iron some items, but others to be fully dried).

After this cycle, the Audio (Buzzer) will sound (if selected) to remind you that

the clothes are ready to take out. To cancel turn the Timer to 0, or push the

option button. We recommend that the clothes are removed immediately this

programme ends to minimise creasing.

This light will glow when Auto drying is selected. It will stop glowing when the

load is dry and the programme advances to the cool tumble phase.

This light glows during any drying programme and goes out at the start of the

cool tumble phase.

The button is OUT for ‘LOW’ heat and IN for ‘HIGH’ heat.

The choice of FULL HEAT or LOW HEAT depends upon the fabric you wish to

dry (see section ‘Sorting your Laundry’).

Your dryer is fitted with an alarm to remind you when the clothes are ready to

take out. The alarm is selected with the button IN and cancelled with the

button OUT.

NEVER SWITCH THE DRYER ‘OFF’ WITH A HOT LOAD IN THE

DRUM.

YOU MUST TERMINATE EVERY PROGRAMME WITH THE COOL

TUMBLE PHASE.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire

Hotpoint TDL52 Manuel d'utilisateur Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Séchoirs Hotpoint TDL52