Hotpoint EG52 Manuel d'utilisateur télécharger pdf (Page 7)

CLOCK/MINUTE MINDER OPERATION

TIMER FUNCTION BUTTONS

Minute Minder

Here you can set a time period of up to 23 hours 59 minutes, that will

count down. When it reaches zero, the timer will emit an audible tone.

For Example: If you set 20 minutes, the audible tone will occur 20

minutes later.

SETTING THE MINUTE MINDER

Step 1 Ensure the time of day is set correctly.

Step 2 Press and release the ‘-’ button, a symbol will light up.

Step 3 Within 4 seconds press the ‘+’ button to set the correct

period of time required.

Release the ‘+’ button.

The time is set and will continue to count down and the symbol will

be lit.

At the end of the set time a bleeping sound will be heard and the

symbol will flash for approximately 2 minutes.

After approximately 2 minutes the bleeping sound will stop.

To cancel the symbol flashing, press the ‘-’ button once.

Step 4 To cancel the bleeping sound and the symbol, within the

2 minutes, press the ‘-’ button.

To cancel the minute minder period press the ‘-’ button.

Press the ‘-’ button again until the display shows 0.00

After 5 seconds the display will return to the time of day.

If at any time the display shows flashing zero’s / AUTO, it is likely that

the electricity supply has been interrupted.

Reset the timer to the correct time of day.

NOTE: WHEN THE MINUTE MINDER HAS BEEN SET,THE DISPLAY

WILL REVERT TO SHOW THE TIME OF DAY.

ANY REMAINING TIMED PERIOD CAN BE VIEWED BY

PRESSING THE ‘-’ BUTTON.

Bell Symbol

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Pas de commentaire

Hotpoint EG52 Manuel d'utilisateur Page 7