Hotpoint HTU30 Manuel d'utilisateur télécharger pdf (Page 5)

Installing your Cooker Hood

5

This Cooker Hood is guaranteed and will give

lasting service.

The guarantee is only applicable if the hood

has been installed in accordance with the

installation instructions detailed in this book.

The manufacturer disclaims all liability for any

damage or injury caused as a result of not

following the instructions contained in the

following text.

SAFETY WARNINGS: THIS COOKER HOOD IS

DESIGNED FOR DOMESTIC USE ONLY.

When used in the extraction mode the Cooker

Hood ducting must not be connected to a

flue which is used for exhausting fumes from

a central heating flue or water heating flue.

NOTE: All installations must comply with

local authorities and building regulation

requirements for the discharge of exhaust

air into the atmosphere.

Your new Cooker Hood can be used in the

following ways:

-External exhausting model

- Recycling model

These distances between hobs and grease

filter must be observed.

Minimum 600mm - over an electric hob.

Minimum 700mm - over a gas or mixed fuel

hob.

Minimum 400-450mm - over a high level grill.

Suggestions for the Installation and use:

-The horizontal sections of the pipe must be

slanted slightly upwards (about 10%) to

ensure an easy flow of air outwards.

-The hood is more efficient in the exhaust

mode,therefore this position should be

selected during the warmer months of the

year when no heating is being used.

When the room is being heated, if the

recirculation position is selected heat will

not be wasted.

Ducting:

In order to obtain satisfactory air extraction,

long ducts should not be used. Exhaust pipes

with a minimum internal diameter of 100mm

and with as smooth an inner wall as possible

are recommended. The ducting MUST be

manufactured from a fire retardant material.

Fit the ducting spigot into the aperture on the

top of the casing and make an airtight

connection (Fig. 1 ).

The maximum length of ducting, including

one 90˚ bend should be 3 metres,to be

reduced by 1 metre for each 90˚ bend

installed in the duct run.

Where flexible ducting is fitted it should not

be turned through very tight bends as this

could impair the performance of the hood.

Wall Vent Kit:

For connecting the Hood either directly

through a wall or in conjunction with a

ducting pipe, we recommend the use of a

Wall Vent Kit. A 3m extension pipe is also

available. These may be obtained from your

nearest retailer or the Genuine Parts and

Accessories Mail Order Hotline (see back

cover) and must be used where there is a

cavity wall. Specific installation instructions

are included with the Wall Vent Kit.

NOTE:The Wall Vent Kit has a diameter of

100mm.

Use

The hood may be used in two ways:

- External exhausting version

- Internal recycle version.

External exhausting version.

This method is recommended if at all possible.

The air is conveyed out through a pipe which

is connected to the outlet hole A (fig. 1) by

means of a coupling flange B (fig. 1).

Diameter of the exhausting pipe must be

equal to that of the coupling flange.

Attention! the hood is supplied with a grease

filter, which when absorbed with grease and

fat can be thrown away.

Internal recycle version.

The air is purified through an active carbon

filter and returned to the room.

For instructions on how to fit and replace the

carbon filter please see the section on “ caring

for your cooker hood”.

Fig.1

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire