Hotpoint HM 7030 E C AA O3.1 Guide de l'utilisateur Page 4

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 4
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 3
400011231802
You can download the Safety Instructions, User Manual, Product Fiche and Energy data by:
Visiting our website docs . hotpoint . eu
Using QR Code
Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When
contacting our After-sales Service, please state the codes provided on your product's identication plate.
What to do if... Possible reasons Solutions
The temperature inside the
compartments is not low
enough.
There could be various causes (see
“Solutions”).
Check that:
the doors close properly;
the appliance is not installed near a heat source;
the set temperature is adequate;
the circulation of air through the ventilation of the appliance is
ensured.
There is water on the
bottom of the refrigerator
compartment.
The defrost water drain is blocked. Clean the defrosting water drain (see section “Cleaning and
Maintenance").
The front edge of the
appliance, at the door striker
seal, is hot.
This is not a defect. It prevents
condensation from forming.
No solution is necessary.
The red
icon is ashing
and a sound signal is
activated
Door open alarm
It is activated when the refrigerator and/
or freezer compartments door remains
open for a prolonged period of time.
To turn the sound signal o, close the open door of the product.
The red
icon is ashing,
a sound signal is activated
and the
icon is
activated.
Blackout alarm
This activates when there is a prolonged
interruption to the power supply which
has caused an increase in temperature
in the freezer compartment.
Note: until the blackout alarm is
deactivated, you cannot set a dierent
temperature for the product.
Before turning o the sound signal, it is recommended that you pay
attention to the temperature shown on the temperature display,
corresponding to the highest temperature reached in the freezer
compartment during the power cut. To turn the sound signal o,
briey press the “Turn o sound alarm” button.
After pressing the button, the temperature display will again show
the temperature set. If the freezer compartment has not yet reached
the optimal temperature for the preservation of the food, the
freezer compartment temperature alarm may activate (see freezer
compartment temperature alarm). Check the condition of the food
before consuming it.
The red
icon is lit up
(without ashing), a sound
signal is activated and the
freezer temperature display
is ashing.
Freezer compartment temperature
alarm
The freezer compartment temperature
alarm indicates that the compartment
is not at the optimum temperature. This
may occur: when using for the rst time,
after defrosting and/ or cleaning, when
freezing large quantities of food or
when the door to the freezer does not
close completely.
To turn o the sound signal, briey press the “Turn o sound alarm”
button (the temperature display will stop ashing). When the
optimum temperature conditions have been reached, the red icon will
automatically turn o. If the freezer compartment temperature alarm
continues, contact the Authorised Technical Assistance Service.
The red
icon will light
up, a sound signal is
activated and the letter “F”
is ashing on the display.
Malfunction alarm
The alarm indicates the malfunction of a
technical component.
Call the authorized Technical Assistance Service. To turn the sound
signal o, briey press the “Turn o sound alarm” button.
* Available only on certain models
Vue de la page 3
1 2 3 4

Commentaires sur ces manuels

Pas de commentaire