Hotpoint II C50 AA0 UK Mode d'emploi télécharger pdf (Page 7)

hotpoint.co.uk

The power supply cable must never be bent

or dangerously compressed.

The power supply cable must only be repla-

ced by an authorised serviceman.

BEFORE USE

BeforeusingtheCompactGeneratorforthersttime,

remove all stickers, protective plastic or cardboard

packaging from the soleplate of the iron.

Make sure that all adhesive parts have been removed

from the soleplate using a damp soft cloth and remove

any residues or particles from the manufacturing

processbyrepeatedlyllingandemptyingthewater

reservoir.

When you switch on the Compact Generator

for the rst time, you may notice an

unpleasant smell, a little smoke and some

impurities. They will disappear in a few minutes.

When using the steam function for the rst time,

do not direct the steam jet on the garments

because manufacturing residues may be present

in the steam dispenser.

FILLING THE WATER

RESERVOIR

Water plays an essential role both in the ironing

process and in the good operation of the iron in time.

In particular, a high concentration of limescale may

damage some parts of the Compact Generator and

cause its early deterioration.

Water to be used

We recommend using demineralised water.

Filling the water reservoir (A)

BeforellingthereservoiroftheCompactGenerator

with water, make sure that the iron has been switched

off and disconnected from the electrical socket.

Removing the plug

If your appliance has a non-rewireable moulded plug

and you should wish to re-route the mains cable throu-

gh partitions, units etc., please ensure that either:

• the plug is replaced by a fused 13 ampere rewi-

reable plug bearing the BSI mark of approval.

or:

• the mains cable is wired directly into a 13 amp

cable outlet, controlled by a switch, (in complian-

ce with BS 5733) which is accessible without

moving the appliance.

Disposing of the plug

Ensure that before disposing of the plug itself, you

make the pins unusable so that it cannot be acciden-

tally inserted into a socket.

Instructions for connecting cable to an

alternative plug

The wires in the mains lead are coloured in

accordance with the following code:

GREEN & YELLOW EARTH

BLUE NEUTRAL

BROWN LIVE

As the colours of the wires in the lead may not corre-

spond with the coloured markings identifying the ter-

minals in your plug, proceed as follows:

• Connect Green & Yellow wire to terminal marked

E or

or coloured Green or Green & Yellow.

• Connect Brown wire to terminal marked L or co-

loured Red.

• Connect Blue wire to terminal marked N or co-

loured Black.

Ifa13ampplug (BS1363)isuseditmustbetted

with a 13 amp fuse, either in the plug or adaptor or at

the distribution board.

If you are in any doubt regarding the electrical supply

toyourmachine,consultaqualiedelectricianbefore

use.

How to connect an alternative plug

The wires in this mains lead are coloured in accordan-

ce with the following code:

BLUE NEUTRAL (N)

BROWN LIVE (L)

GREEN & YELLOW EARTH (E)

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire

Hotpoint II C50 AA0 UK Mode d'emploi Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Fers à repasser Hotpoint II C50 AA0 UK