Hotpoint FE 100/IX Mode d'emploi Page 12

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 11
15
TROUBLESHOOTING GUIDE
Oven not working:
Check for the presence of mains electrical power
and if the oven is connected to the electrical
supply.
Turn off the oven and restart it to see if the fault
persists.
IMPORTANT:
Check that the oven control knob is not turned
to “0” or to “lamp” .
If the electronic programmer (depending on
model) display presents the message
”, consult the product description
sheet provided separately and/or the
electronic programmer description.
- If the electronic programmer (depending on
the model) presents the message “F XX”,
contact the nearest After Sales Service.
Specify in this case the number that follows
the letter “F”.
AFTER SALES SERVICE
Before you call the After Sales Service:
1. Try to solve the problem yourself following
the points described in “Troubleshooting
Guide”.
2. Turn the appliance off and on again, to make
sure that the problem has been solved.
If after the above checks the fault still occurs,
get in touch with the nearest After Sales
Service.
Please give:
a brief description of the fault;
the type and exact model of the oven;
the service number (number after the word
Service on the rating plate), located on the
right hand edge of the oven cavity (visible
when the oven door is open). The service
number is also indicated on the guarantee
booklet;
your full address;
your telephone number.
If any repairs are required, please contact an
authorised After Sales Service (to guarantee
that original spare parts will be used and repairs
carried out correctly).
Failure to comply with these instructions may
compromise the safety and quality of the
product.
DECLARATION OF CONFORMITY
This oven is designed to come into contact
with food and complies with regulation (EC)
no.1935/2004.
This appliance is designed to be used for
cooking only.
Any other use (e.g. for room heating) is
considered as improper use and potentially
dangerous.
This appliance has been designed,
constructed and marketed in compliance
with:
- the safety requirements of “Low
Voltage” Directive 2006/95/EC
(replacing 73/23 EEC as amended);
- the protection requirements of EMC
Directive 89/336/EEC;
- the requirements of Directive 93/68/EEC.
Vue de la page 11
1 2 ... 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire