Hotpoint RVM5160DHBB Manuel d'installation télécharger pdf (Page 9)

Installation Instructions

Find the studs, using one of the following methods:

A. Stud finder.

B. Use a hammer to tap lightly across the mounting

surface to find a solid sound. This will indicate

a stud location.

After locating the stud(s), find the center by probing

the wall with a small nail to find the edges of the stud.

Then place a mark halfway between the edges.

The center of any adjacent studs should be 16s or 24s

from this mark.

Draw a line down the center of the studs.

IMPORTANT: The microwave must be connected to at

least one wall stud.

Open the box and fold back all four carton flaps fully

against the carton sides. Remove the following items

from the protective foam: installation instructions,

filters, exhaust adaptor, damper, and the small

hardware bag. Do not remove the foam protecting

the front of the microwave oven.

Then carefully roll the microwave oven and carton

over onto the top side. The microwave oven should

be resting in the foam.

REMOVING THE MICROWAVE

29(1)5207+(&$5721

REMOVING THE MOUNTING PLATE

FINDING THE WALL STUDS

PLACEMENT OF THE MOUNTING PLATE

Wall

Studs

Center

Carton

Pull the carton up and off the microwave oven.

Open the microwave oven door and remove the

plastic sheet and tape from inside the microwave

oven door. Remove the tape covering the turntable

hub.

Foam

Set the microwave oven upright. Remove and

properly discard plastic bags and foam.

The mounting plate is attached to the back of the

microwave oven. Remove the two screws holding it

to the microwave oven. The plate will be used as the

rear wall template and for mounting the microwave

oven to the wall.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

Hotpoint RVM5160DHBB Manuel d'installation Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Micro-ondes Hotpoint RVM5160DHBB