Hotpoint MS5 744 IX A Guide d'utilisation et d'entretien Page 8

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 13
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 7
8
KEY LOCK
The key lock will be active within 30 seconds after
the last button pression. The
icon will appear on
display. To deactivate it, long press the time button.
4. PREHEATING
Once the function has been activated, the LED
thermostat will switch on signalling that the
preheating process has begun.
At the end of this process, the LED thermostat
switches off indicating that the oven has reached the
set temperature: at this point, place the food inside
and proceed with cooking.
Please note: placing the food in the oven before preheating
has nished may have an adverse eect on the nal cooking
result.
COOLING SYSTEM
The cooling fan may switch itself on every so
often during cooking in order to reduce energy
consumption.
Once cooking is complete and the oven has been
switched off, the cooling fan may continue to run for
a certain period of time.
CLEANING AND MAINTENANCE
Make sure that the oven has
cooled down before carrying out
any maintenance or cleaning.
Do not use steam cleaners.
Do not use wire wool, abrasive
scourers or abrasive/corrosive
cleaning agents, as these could
damage the surfaces of the
appliance.
Wear protective gloves.
The oven must be disconnected
from the mains before carrying
out any kind of maintenance work.
EXTERIOR SURFACES
Clean the surfaces with a damp microfibre cloth.
If they are very dirty, add a few drops of pH-neutral
detergent. Finish off with a dry cloth.
Do not use corrosive or abrasive detergents. If
any of these products inadvertently comes into
contact with the surfaces of the appliance, clean
immediately with a damp microfibre cloth.
INTERIOR SURFACES
After every use, leave the oven to cool and then
clean it, preferably while it is still warm, to remove
any deposits or stains caused by food residues To
dry any condensation that has formed as a result
of cooking foods with a high water content, let the
oven to cool completely and then wipe it with a
cloth or sponge.
Clean the glass in the door with a suitable liquid
detergent.
The oven door can be removed to facilitate
cleaning.
ACCESSORIES
Soak the accessories in a washing-up liquid solution
after use, handling them with oven gloves if they
are still hot. Food residues can be removed using a
washing-up brush or a sponge.
REPLACING THE LAMP
Disconnect the oven from the power supply.
Unscrew the cover from the lamp, replace the bulb
and screw the cover back on the lamp.
Reconnect the oven to the power supply.
Please note: Only use 15-25 W/220-240 V type G9, T300°C
halogen bulbs. The bulb used in the product is specically
designed for domestic appliances and is not suitable for
general room lighting within the home (EC Regulation
244/2009).
Light bulbs are available from our After-Sales Service.
When using halogen bulbs, do not handle them with your
bare hands as your ngerprints could cause damage. Do not
use the oven until the lamp cover has been retted.
REMOVING AND REFITTING THE DOOR
To remove the door, open it fully and lower the
catches until they are in the unlock position.
Set the hinge lock to the widest angle. Adjust both
hinges connecting oven door to the oven to the same
position.
Later, close the opened oven door so that it will be in
a position to contact with hinge lock.
Vue de la page 7
1 2 3 4 5 6 7 8 9 10 11 12 13

Commentaires sur ces manuels

Pas de commentaire