Hotpoint RGB744 Manuel d'utilisateur télécharger pdf (Page 39)

ELECTRICAL CONNECTIONS

(on some models)

Electrical Requirements

120-volt, 60 Hertz, properly grounded branch

circuit protected by a 15-amp or 20-amp circuit

breaker or time delay fuse.

Extension Cord Cautions

Because of potential safety hazards associated

with certain conditions, we strongly recommend

against the use of an extension cord. However,

if you still elect to use an extension cord, it is

absolutely necessary that it be a UL-listed,

3-wire grounding-type appliance extension cord

and that the current carrying rating of the cord

in amperes be equivalent to, or greater than,

the branch circuit rating.

Grounding

IMPORTANT—(Please read carefully)

FOR PERSONAL SAFETY, THIS APPLIANCE

MUST BE PROPERLY GROUNDED.

The power cord of this appliance is equipped

with a three-prong (grounding) plug which

mates with a standard three-prong grounding

wall receptacle

to minimize the

possibility of

electric shock

hazard from

this appliance.

The customer

should have the

wall receptacle

and circuit

checked by a

qualified electrician to make sure the receptacle

is properly grounded.

Where a standard two-prong wall receptacle is

encountered, it is the personal responsibility and

obligation of the customer to have it replaced with

a properly grounded three-prong wall receptacle.

DO NOT, UNDER ANY CIRCUMSTANCES,

CUT OR REMOVE THE THIRD (GROUND)

PRONG FROM THE POWER CORD.

CONNECT THE RANGE TO GAS

(continued)

1. Install a manual gas line shut-off valve in the

gas line in an easily accessed location outside of

the range. Make sure everyone operating the

range knows where and how to shut off the gas

supply to the range.

2. Install male 1/2″ flare union adapter to the

1/2″ NPT internal thread elbow at inlet of

regulator. On models equipped with dual

burners, install the male pipe thread end of

the 1/2″ flare union adapter to the 1/2″ NPT

internal thread at inlet of pressure regulator.

Use a backup wrench on the regulator fitting

to avoid damage.

When installing the range from the front,

remove the 90° elbow for easier installation.

3. Install male 1/2″ or 3/4″ flare union adapter

to the NPT internal thread of the manual shut-

off valve, taking care to back-up the shut-off

valve to keep it from turning.

4. Connect flexible metal appliance connector

to the adapter on the range. Position range

to permit connection at the shut-off valve.

5. When all connections have been made, make

sure all range controls are in the off position and

turn on the main gas supply valve. Use a liquid

leak detector at all joints and connections to

check for leaks in the system.

When using test pressures greater than 1/2 psig

to pressure test the gas supply system of the

residence, disconnect the range and individual

shut-off valve from the gas supply piping. When

using test pressures of 1/2 psig or less to test the

gas supply system, simply isolate the range from

the gas supply system by closing the individual

shut-off valve.

CAUTION: DO NOT USE A FLAME TO

CHECK FOR GAS LEAKS.

PREFERRED

METHOD

Ensure proper

ground exists

before use

(continued next page)

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Hotpoint RGB744 Manuel d'utilisateur Page 39

Commentaires sur ces manuels

Produits connexes et manuels pour Radio Hotpoint RGB744