Hotpoint FI7 891 SP IX HA Mode d'emploi télécharger pdf (Page 10)

EXTERIOR SURFACES

• Clean the surfaces with a damp microfibre cloth.

If they are very dirty, add a few drops of pH-neutral

detergent. Finish off with a dry cloth.

• Do not use corrosive or abrasive detergents. If any of

these products inadvertently comes into contact with

the surfaces of the appliance, clean immediately with

a damp microfibre cloth.

INTERIOR SURFACES

• After every use, leave the oven to cool and then

clean it, preferably while it is still warm, to remove any

deposits or stains caused by food residues.

To dry any condensation that has formed as a result

of cooking foods with a high water content, leave the

oven to cool completely and then wipe it with a cloth

or sponge.

• Clean the door glass with a suitable liquid detergent.

• The oven door can be removed to facilitate cleaning.

ACCESSORIES

Soak the accessories in a washing-up liquid solution

after use, handling them with oven gloves if they

are still hot. Food residues can be removed using a

washing-up brush or a sponge.

CLEANING THE COOKING COMPARTMENT WITH THE PYRO CYCLE

Make sure that the oven has

cooled down before carrying out

any maintenance or cleaning.

Do not use steam cleaners.

Do not use wire wool, abrasive

scourers or abrasive/corrosive

cleaning agents, as these could

damage the surfaces of the

appliance.

Wear protective gloves.

The oven must be disconnected

from the mains before carrying

out any kind of maintenance

work.

REPLACING THE LIGHT

1. Disconnect the oven from the power supply.

2. Unscrew the cover from the light, replace the bulb

and screw the cover back on the light.

3. Reconnect the oven to the power supply.

Please note: Only use 25-40 W/230 V type E-14, T300 °C

incandescent bulbs, or 20-40 W/230 V type G9, T300 °C

halogen bulbs. The bulb used in the product is specically

designed for domestic appliances and is not suitable for

general room lighting within the home (EC Regulation

244/2009). Light bulbs are available from our After-sales

Service.

- If using halogen bulbs, do not handle them with your bare

hands as your ngerprints could cause damage. Do not use

the oven until the light cover has been retted.

MAINTENANCE AND

CLEANING

Download the Use and Care Guide from

docs.hotpoint.eu for more information

WWW

This function enables you to eliminate cooking

spatters using a temperature of approx. 500 °C. At this

temperature, food residues turn into deposits that can

be easily wiped away with a damp sponge once the

oven has cooled down.

If the oven is installed below a hob, make sure that

all the burners or electric hotplates are switched off

while running the self-cleaning cycle.

Remove all accessories from the oven before

running the Pyro function (including the shelf

guides).

For optimum cleaning results, remove the worst

soiling with a damp sponge before using the Pyro

function.

Then oven has two different pyrolytic cleaning

functions: The standard cycle (PYRO) provides

thorough cleaning if the oven is heavily soiled, while

the economic cycle (PYRO EXPRESS) is shorter and

consumes less energy than the standard cycle, which

makes it suitable for use at regular intervals.

Only run the Pyro function if the appliance contains

heavy soiling or gives off bad odours during cooking.

Please note: The oven door cannot be opened while

pyrolytic cleaning is in progress. It will remain locked until the

temperature has returned to an acceptable level.

Air the room during and after running the Pyro cycle.

Do not touch the oven during the Pyro cycle. Keep children and animals away from the oven

during and after (until the room has nished airing)

running the Pyro cycle.

1 2 ... 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire

Hotpoint FI7 891 SP IX HA Mode d'emploi Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Non Hotpoint FI7 891 SP IX HA