Hotpoint IKIU 631 FLT F Mode d'emploi télécharger pdf (Page 13)

EN13

IMPORTANT: Do not use abrasive sponges or scouring pads. Their use could eventually ruin the glass.

• After each use, clean the hob (when it is cool) to remove any deposits and stains due to food residuals.

• Sugar or foods with a high sugar content damage the hob and must be immediately removed.

• Salt, sugar and sand could scratch the glass surface.

• Use a soft cloth, absorbent kitchen paper or a specific hob cleaner (follow the Manufacturer’s instructions).

• Liquid splillages on the cooking zones may make pan vibrate or move

• Dry the hob thoroughly after cleaning it.

• Read and follow the instructions given in the section “Instructions for use”.

• Check that the electricity supply has not been shut off.

• Dry the hob thoroughly after cleaning it.

• If, when the hob is switched on, alphanumeric codes appear on the display, consult the following table for instructions.

• If the hob cannot be switched off after using it, disconnect it from the power supply.

Induction hobs can make whistling or crackling sounds during normal operation, these actually come from the pots and pans as a result of the characteristics of the

bottoms (for example, bottoms made of several layers of material, or uneven bottoms). These noises vary depending on the pots and pans used and the amount of food

they contain, and are not indicative of a defect of any kind.

In addition, the induction hob is equipped with an internal cooling system to control the temperature of electronic parts; as a result, during operation and for several minutes

after the hob has been switched off, the noise of the cooling fan will be audible. This is perfectly normal and indeed essential for proper functioning of the appliance.

Before contacting the After-sales Service:

1. See if you can solve the problem yourself with the help of the “Troubleshooting guide”.

2. Switch the appliance off and then on again it to see if the problem has been eliminated.

If the problem persists after the above checks, contact the nearest After-Sales Service.

Always specify:

• a brief description of the fault;

• the product type and exact model;

• the serial number located under the appliance, also available in the attached technical documentation.

• your full address;

• your telephone number.

If any repairs are required, contact an

authorised After-Sales Service Centre

(to ensure the use of original spare parts and correct repairs). Spare parts are available for 10 years.

CLEANING

WARNING

- Do not use steam cleaners.

- Before cleaning, make sure the cooking zones are switched off and that the residual heat indicator (“H”)

is not displayed.

TROUBLESHOOTING GUIDE

ERROR CODE DESCRIPTION POSSIBLE CAUSES ERROR ELIMINATION

C81, C82

The control panel switches off because

of excessively high temperatures

The internal temperature of electronic

parts is too high

Wait for the hob to cool down

before using it again.

F42 or F43 The connection voltage is wrong

The sensor detects a discrepancy

between the appliance voltage and

that of the mains supply

Disconnect the hob from the

mains and check the electrical

connection

F12, F21, F25, F36, F37, F40, F47,

F56, F58, F60

Call the After-Sales Service and specify the error code

NOISES MADE BY THE HOB

AFTER-SALES SERVICE

1 2 ... 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Hotpoint IKIU 631 FLT F Mode d'emploi Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Non Hotpoint IKIU 631 FLT F