Hotpoint WMTL80 Manuel d'utilisateur télécharger pdf (Page 8)

6. Connect to a Drainage System...

●

Connect up the drain hose, after fitting the hooked end support supplied in the

machine.

●

Do not position standpipe near an electrical outlet.

●

For drainage into a standard worktop sink ensure the outlet pipe has a minimum

bore of 32mm.To avoid syphoning ensure the end of the drainage hose is above

the water level in the sink.If your sink is inset, the front edge of the basin must be

less than 75mm from the front edge of your worktop (Fig 1).

We recommend one of the following drainage methods:-

Standpipe

Note: Ensure the standpipe has a minimum diameter of 38 mm.

1. Ensure hooked end of drain hose is

positioned between 90 and 65cm above

the bottom of the machine (Fig 2).

2. Untie the end of the GREY drainage

hose from the rear of the appliance and

place approximately 100 mm into the

standpipe or sink trap spigot.

The waste water can be drained onto the ground, so long as the drain hose passes

through a point between 90 and 65cm higher than the bottom of the machine (Fig 2).

Sink Waste System

Note: Ensure the sink outlet pipe has a minimum diameter of 32 mm.

1. Untie the end of the GREY drainage hose from the rear of the appliance.

2. Reposition ‘Hooked End Support’ as required along the GREY drainage hose.

3. If fitting an under sink waste disposal unit

(Fig 3), cut out the membrane, bung or

blanking plug.

4. Attach the GREY drainage hose to the under

sink waste disposal unit securely, using a hose

clip.

5. Raise the hose to a minimum height of between

90 and 65cm to avoid syphoning.

●

Ensure the drain hose is securely attached, to prevent it coming away while the

machine is in use and causing a flood.

When you have installed your

appliance, ensure it is ready to use by

following this 10 Step Check List

1. Dispose of packaging safely,

see ‘Recycling Information’.

2. Position appliance close to

electrical/water supply.

3. Remove all four Transit Fixing

Bolts.

4. Connect supplied hoses to

appliance water supply, confirm

water is flowing before connecting

to the appliance inlet valves.

5. Untie drainage hose at rear of

appliance and connect to a drainage

system see ‘Drainage’opposite.

6. Untie mains lead at rear of

appliance and plug into electrical

supply via a switched socket,

see ‘Electrical Supply’.

7. Position appliance, taking care not to

kink or damage hoses at rear of

appliance.

8. Ensure the appliance is level.

9. Turn on the water supply

to the appliance.

10. Switch on at plug socket.

10 St

heck List

Fig 1

Fig 2

●

Your appliance is now ready for use,

refer to ‘Getting to Know Your

Appliance’, to familiarise yourself

with the appliance.

Fig 3

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Hotpoint WMTL80 Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Rondelles Hotpoint WMTL80