Hotpoint HSB 7M124 B EU Mode d'emploi télécharger pdf (Page 12)

Detergent and

dishwasher use

* Only available in selected models.

Measuring out the detergent

A good wash result also depends on the correct

amount of detergent being used. Exceeding the stated

amount does not result in a more effective wash and

increases environmental pollution.

Based on how soiled the items are, the amount can be

adjusted to individual cases using powder or liquid

detergent.

In the case of normally soiled items, use approximately either

35 gr (powder detergent) or 35 ml (liquid detergent). If tablets

are used, one tablet will be enough.

If the crockery is only lightly soiled or if it has been rinsed

with water before being placed in the dishwasher, reduce the

amount of detergent used accordingly.

For good washing results also follow the instructions shown

on the detergent box.

For further questions please ask the detergent producers.

To open the detergent dispenser use the opening device “A”.

Introduce the detergent into the dry dispenser “B” only.

Place the amount of detergent for pre-washing directly inside

the tub.

1. When measuring out the detergent refer to the Table of wash

cycles to add the proper quantity. Compartment B comprises a

level showing the maximum quantity of liquid or powder detergent

that can be added to each cycle.

2. Remove detergent residues from the edges of the dispenser

and close the cover until it clicks.

3. Close the lid of the detergent dispenser by pulling it up until

the closing device is secured in place.

The detergent dispenser automatically opens up at the right time

according to the wash cycle.

If all-in-one detergents are used, we recommend using the TABS

option, because it adjusts the cycle so that the best washing and

drying results are always achieved.

Only use detergent which has been specifically designed

for dishwashers.

DO NOT USE washing up liquid.

Using excessive detergent may result in foam residues

remaining in the machine after the cycle has ended.

To achieve the best washing and drying results, the combined

use of detergent, rinse aid liquid and refined salt is required.

We recommend using detergents that do not contain

phosphates or chlorine, as these products are harmful

to the environment.

Starting the dishwasher

1. Turn the water tap on.

2. Press the ON/OFF button:

3. Open the door and pour in a suitable amount of detergent.

4. Load the racks

(see Loading the racks)

and shut the door.

Select the wash cycle by turning the WASH CYCLE

SELECT knob clockwise: align the notch in the knob with

the number/symbol representing the desired wash cycle. The

START/PAUSE indicator light will go on.

6. Select the wash options*

(see Special wash cycles and

options.)

7. Start the cycle by pressing the Start/Pause button: a beep will

sound

* and the indicator light corresponding to the wash

phase will go on to signal that the cycle has begun.

8. At the end a few beeps * will signal the end of the wash cycle

and the END indicator light will go on. Switch off the appliance

by pressing the ON/OFF button, shut off the water tap and unplug

the appliance from the electricity socket.

9. Wait a few minutes before removing the crockery to avoid

getting burnt. Unload the racks, beginning with the lower level.

- The machine will switch off automatically during

certain periods of inactivity in order to minimise

electricity consumption.

Changing a wash cycle in progress

If a mistake was made in the wash cycle selection process, it

is possible to change the cycle provided that it has only just

begun: once the wash cycle has started, in order to change

the wash cycle switch off the machine by pressing and holding

the ON/OFF/Reset button. Switch it back on using the same

button and select the desired wash cycle and options.

Adding extra crockery

Press the Start/Pause button - the corresponding indicator

light will flash. Open the door, taking care to avoid the

escaping steam, and place the crockery inside the appliance.

Press the Start/Pause button (fixed light): the cycle starts

again.

If the Start/Pause button is pressed so as to pause the

machine, both the wash cycle and the Delayed Start function

(if selected) are interrupted.

At this stage the wash cycle cannot be changed.

Accidental interruptions

If the door is opened during the wash cycle or there is a

power cut, the cycle stops. It starts again from the point at

which it was interrupted once the door has been shut or the

electricity supply restored.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Hotpoint HSB 7M124 B EU Mode d'emploi Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle Hotpoint HSB 7M124 B EU