Hotpoint LSF 712 AG Mode d'emploi télécharger pdf (Page 24)

Troubleshooting

Whenever the appliance fails to work, check for a solution from the following list before calling for Assistance.

* Only available in selected models.

Problem: Possible causes / Solutions:

The dishwasher does not start or

cannot be controlled

• SwitchofftheappliancebypressingtheON/OFFbutton,switchitbackonafter

approximately one minute and reset the program.

• Theappliancehasnotbeenpluggedinproperly.

• Thedishwasherdoorhasnotbeenshutproperly.

The door won’t close • Thelockwasreleased.Stronglypushthedooruntila“clacking”noiseisheard.

No water drains out from the

dishwasher.

• Thedishwashercyclehasnotyetnished.

• Thewaterinlethoseisbent(see Installation).

• Thedrainductisblocked.

• Thelteriscloggedupwithfoodresidues.

The dishwasher makes excessive

noise.

• Thedishesarerattlingagainsteachotheroragainstthesprayerarms.

• Anexcessiveamountoffoamhasbeenproduced:thedetergenthasnotbeen

measured out correctly or it is not suitable for use in dishwashers (see Start-up and

use).

The dishes and glasses are

covered in a white lm or

limescale deposits.

• Theleveloftherenedsaltisloworthedosagesettingisnotsuitedtothehardnessof

the water (see Rinse aid and salt).

• Thelidonthesaltdispenserisnotclosedproperly.

• Therinseaidhasbeenuseduporthedosageistoolow.

The dishes and glasses are

streaked or have a bluish tinge.

• Therinseaiddosageistoohigh.

The crockery has not been dried

properly.

• Awashcyclewithoutadryingprogramhasbeenselected.

• Therinseaidhasbeenuseduporthedosageistoolow(see Rinse aid and salt).

• Therinseaiddispensersettingisnotsuitable.

• Thecrockeryismadefromnon-stickmaterialorplastic.

The dishes are not clean. • Theracksareoverloaded(seeLoadingtheracks).

• Thecrockeryhasnotbeenarrangedwell.

• Thesprayerarmscannotmovefreely.

• Thewashcycleistoogentle(see Wash cycles).

• Anexcessiveamountoffoamhasbeenproduced:thedetergenthasnotbeen

measured out correctly or it is not suitable for use in dishwashers (see Start-up and

use).

• Thelidontherinseaidcompartmenthasnotbeenshutcorrectly.

• Thelterisdirtyorblocked(seeCareandmaintenance).

• Therenedsaltlevelislow(seeRinseaidandsalt).

The dishwasher does not take any

water in - Tap shut-off alarm

(several short beeps are emitted*)

(the Drying and End indicator lights

ash).

• Thereisnowaterinthemainssupply.

• Thewaterinlethoseisbent(seeInstallation).

• Turnonthetapandtheappliancewillstartafterafewminutes.

• Theappliancelockhasbeenactivatedbecausenoactionwastakenwhenthebeeps*

sounded. Switch off the appliance using the ON/OFF button, turn on the tap and switch

the appliance back on after 20 seconds by pressing the same button. Re-program the

appliance and restart the wash cycle.

Water inlet hose alarm / Water inlet

lter blocked

(the Washing, Drying and End

indicatorlightsashes).

• SwitchofftheappliancebypressingtheON/OFFbutton.Shutoffthewatertapto

eliminatetheriskofoodingandremovetheplugfromtheelectricalsocket.

 Makesurethewaterinletlterhasnotbecomeblockedbyimpurities(see“Careand

maintenance”chapter).

195087147.01

10/2013pb-XeroxFabriano

1 2 ... 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire

Hotpoint LSF 712 AG Mode d'emploi Page 24

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle Hotpoint LSF 712 AG