Hotpoint CF 16 2 Mode d'emploi télécharger pdf (Page 9)

5. The compressor runs continuously.

• Have hot foods been put in the appliance?

• Has the appliance lid been left open for a long time?

• Is the appliance positioned in a very warm room or near

heat sources?

• Is the thermostat setting correct?

• Has the fast freeze function (depending on model) been

pressed by mistake?

6. Too much ice on the upper edge.

• Are the defrost water drainage plugs correctly positioned?

• Is the appliance lid properly closed?

• Is the appliance lid seal damaged or deformed?

(See chapter “Installation”)

• Have the 4 protection pieces been removed?

(See chapter “Installation”)

7. Condensation forms on the external walls of the

appliance

• It is normal for condensation to form under certain

atmospheric conditions (humidity above 85%) or if the

appliance is located in a damp or poorly ventilated room.

The performance of the appliance is in no way a ected.

8. The layer of ice on the internal walls of the appliance is

not uniform.

• This phenomenon is quite normal.

AFTERSALES SERVICE

Before contacting After-Sales Service:

1. See if you can solve the problem yourself.

2. Switch the appliance on again to see if the problem has

been solved. If it has not, disconnect the appliance from

the power supply and wait for about an hour before

switching on again.

3. If the problem persists after this course of action, contact

After- Sales Service.

Specify:

• the nature of the fault,

• the model,

• the service number (the number after the word SERVICE on

the rating plate on the rear of the appliance)

• your full address,

• your telephone

number and area

code.

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Hotpoint CF 16 2 Mode d'emploi Page 9