Hotpoint SC98 Manuel d'utilisateur télécharger pdf (Page 14)

Care and Cleaning

- Always unplug the appliance from the mains or switch

off the main switch before all operations.

Inside the oven

We recommend you clean your oven each time you use it,

especially after cooking roasts. In fact, it is advisable to

prevent food residue from building up during cooking: the

residue would be re-cooked each time the oven is used

and would char and release smoke and unpleasant

odours.

Oven exterior

Clean the enamelled or stainless steel exterior surfaces of

your oven using a sponge soaked in soapy water, making

sure you rinse and dry these thoroughly, without using

abrasive or corrosive products which could damage them.

Stainless steel

Rinse stainless steel parts and dry them thoroughly using

a soft cloth. Use a specific non-abrasive product to remove

tougher stains,

DO NOT use aluminium foil to line the bottom of the

oven.

To avoid having to clean the bottom of the oven, you must

never be tempted to line it with some aluminium foil. We

strongly advise against this. The aluminium foil sheet

in direct contact with the heated enamel coating could

melt and damage the enamel coating inside the oven

irreversibly.

Cleaning the rotisserie and other accessories

The rotisserie can be removed completely using the 2 wing

nuts. The elements comprising the rotisserie assembly

should be cleaned together with the other accessories

(baking tray) in the sink using a damp sponge and ordinary

detergent or in your dishwasher.

Rubber Seal

There is a rubber seal surrounding the oven opening which

guarantees its perfect functioning. Check the condition of

this seal on a regular basis. If necessary, clean it using

warm water and dry thoroughly.

DO NOT use abrasive products or objects to do so. Should

the seal become damaged, please contact Hotpoint Service

(see KEY CONTACTS, back page). We recommend you

avoid using the oven until it has been repaired.

Disassembling the oven door

The oven door can easily be removed to clean the space

between the bottom of the door and the front of the oven. To

disassemble the door, proceed as follows:

- open the oven door fully,

- lift up and turn the small levers situated on the two hinges,

- shut the door, but not completely,

- grip the door on the two external sides and pull it towards

you, pulling it out of its seat.

Reassemble the door by following the above procedures

in reverse order.

ST / SD 98

132

SC 98

123

Replacing the oven lamp

- Always unplug the appliance from the mains or switch

off the main switch before all operations.

- With the aid of a narrow, flat item (such as a screwdriver

or a spoon handle, etc…), remove the glass cover.

- Unscrew the lamp and replace it with another featuring

the same characteristics:

- voltage 230/240 W

- wattage 25 W

- type E 14

- Replace the glass cover and ensure you reposition the

seal correctly.

Glass door

Seal

Lamp

Oven

compartment

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Hotpoint SC98 Manuel d'utilisateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Four Hotpoint SC98