Hotpoint SC98 Manuel d'utilisateur télécharger pdf (Page 18)

Electrical connection

The electrical connection to the mains must be made on

the appliance. The power voltage and frequency are as

indicated on the rating plate.

WARNING: THIS APPLIANCE MUST BE EARTHED.

Mounting the power supply cable

To open the terminal board:

• Using a screwdriver, press on the tabs situated on each

side of the terminal board cover.

• Pull open the terminal board cover.

To mount the power supply cable, proceed as follows:

• Unscrew the cable clamp screw and the contact

screws.

• Position the jumpers accordingly to the type of

connection you wish to make as per the diagrams

below.

• Note: The jumpers are factory set for a 230V single

phase connection.

This appliance conforms to the following EEC

Directives:

Low Voltage Equipment

73/23/EEC

93/68/EEC

Electromagnetic Compatibility

89/336/EEC

93/68/EEC

92/31/EEC

Inner dimensions of the oven:

width 43.5cm

depth 40.0cm

height 32.0cm

Inner volume of the oven: 56 litres

Voltage and frequency of power supply:

230-240V

50-60Hz

2250-2400W

Electrical Connections:

Voltage Frequency: 230 V-1+N 50Hz

Fuse Section: 32A 4mm

You can connect your oven to the system means of a

terminal board. Refer to above information for the minimal

cable sections and the calibration of the protective

elements according to the connection.

If the appliance is installed with a junction box, an

omnipolar circuit breaker - with a minimum contact

opening of 3mm - should be installed between the

appliance and the mains.

Electrical Connection

• Fasten the power supply cable in the corresponding

cable clamp and close the cover.

Power cable supply connection to the electrical

mains:

We recommend you use a power supply cable which is

long enough to allow you to take the oven out of its recess

in the event of maintenance operations (only use HAR - H

05 - RRF quality cables fitted with a plug conforming to

the regulations in force.

The plug must be accessible at all times.

Unplug the appliance before all operations, even when

replacing the oven lamp.

Using the appliance without correct earthing is highly

dangerous.

IMPORTANT:

After connecting the appliance to the flexible cable, tighten

all the screws on the terminal board.

12345

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire

Hotpoint SC98 Manuel d'utilisateur Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Four Hotpoint SC98