Hotpoint E6002 Manuel d'utilisateur télécharger pdf (Page 10)

Electrical Connection - Model E600

Electrical Connection

THIS APPLIANCE MUST BE EARTHED.

The installation procedure must be carried out by a qualified

electrician.

The electrical safety of this appliance is guaranteed only

if the appliance is correctly earthed in compliance with the

standards of electrical safety.

The manufacturer can under no circumstances be

considered responsible for any damage that might occur

due to incorrect earthing of the hob.

The electric hob is not supplied with a power supply chord

because the type of chord used depends on the type of

electrical connection (see the following connection

diagram).

Open the terminal box following the instructions illustrated

in the diagram below:

Voltage and frequency of power supply:

230-240V

50-60Hz

5700W

Electrical Connections:

To connect the supply cord, proceed as follows:

- Loosen the screws on the wire clamp "V", as well as the

screws for the contacts.

- Insert the wires beneath the contact screws, as shown in

the diagram and tighten them.

- Fasten the cord with the appropriate wire clamp and close

the cover.

12345

Fuse 32 A

Connecting the supply cord to the electrical mains:

The hob must be connected to a double pole mains switch

which must be installed between the appliance and the

mains.. The double pole mains switch must have a

minimum of 3mm of space between the contacts, be sized

to the load and comply with current regulations (the switch

must not be able to disconnect the earth conductor).

The supply cord should conform to BS6004 conductor size

4mm

and must be positioned so that no part of it reaches

a temperature of 50°C higher than room temperature.

Before making the connection, make sure that:

• the limiter switch and the residual wiring can support

the appliance load (see the rating plate).

• the mains system is properly earthed in compliance

with current regulations and provisions.

• there is easy access to the socket or the double pole

mains switch after the appliance is installed.

IMPORTANT:

If the hob is installed above a built-in oven, the electrical

connection for the hob must be independent of that for the

oven, both for safety reasons and to facilitate the removal

of the oven for maintenance, repair etc.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Hotpoint E6002 Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Fours Hotpoint E6002