Hotpoint E6002 Manuel d'utilisateur télécharger pdf (Page 9)

Installation - Model E600

These instructions are intended for the qualified technician

installing the appliance in order to insure that the installation,

adjustments and maintenance procedures are performed

correctly and comply with the regulations currently in effect.

Important: the hob must be disconnected from the

power supply before making any adjustments or

performing any maintenance, etc.

Installing built-in hobs

The hob has a type X protection rating against overheating

in compliance with regulation CEI 335-2-6. Therefore, the

hob cannot be installed alongside of cabinets which are

higher than the surface of the hob itself. The following

precautionary measures should be observed in order to

ensure proper installation:

a) Hoods must be installed in compliance with the required

specifications contained in the instruction manual for

the hood itself.

b) The built-in ceramic glass top can be installed on any

counter top as long as it is 600 mm or more in width

and resistant to temperatures of up to 100°C.

The dimensions and the position of the hole are shown

in fig..

575

mm.

505

mm.

560

mm.

+0 -2

490

mm.

+0 -2

mm.

X (CEI 335-2-6)

These measurements must absolutely be observed in

so far as improper installation can cause the surrounding

surface areas to overheat. It is recommended that the

hob be installed at a distance of at least 40 mm from

the back wall or other vertical surfaces to ensure that

the air circulates properly over the cooking area and to

avoid overheating the surrounding surfaces. A seal or

gasket is provided with the hob; make sure that it

adheres properly to the bottom part of the frame of the

hob.

The seal must fit properly around the entire hob frame

and especially along the corners in order to create a

seal between the counter top and the cooktop itself so

as to prevent spills or splashes from leaking into the

cabinet below. Fasten the 4 hooks supplied into the

slots as shown in Fig.;

Fastening diagram for the hooks

Fastening positions Hook placement for

40 and 30 mm tops

Insert the hob into the hole, pressing firmly around the

frame to make it adhere to the counter top.

Important: The surface where the hob is installed must

be perfectly flat. Deformations caused by improper

installation may affect the characteristics of the hob,

and, therefore, its performance.

c) If a wooden panel is installed beneath the hob for

insulation purposes, it must be positioned at least 20

mm from the bottom part of the hob itself.

Note: If the hob is installed above a built-in oven, it is

preferable that the oven be installed in such a way that it

is set on two strips of wood; if, on the other hand, the oven

is installed on a continuous base, there must be an opening

in the back of at least 45 x 560 mm.

560 mm.

45 mm.

If the hob is installed above a built-in oven equipped with a

forced air cooling system, air intake and exhaust slots

must be provided to ensure that the air circulates properly

within the cabinet. Figures provide illustration of possible

installation solutions.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Hotpoint E6002 Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Fours Hotpoint E6002