Hotpoint SH 83 C X Mode d'emploi télécharger pdf (Page 11)

Maintenance and care

Switching the appliance off

Disconnect your appliance from the electricity supply

before carrying out any work on it.

Cleaning the appliance

• The stainless-steel or enamel-coated external parts as

well as the rubber seals may be cleaned using a

sponge that has been soaked in lukewarm water and

neutral soap. If these stains are difficult to remove, use

only specialised products. After cleaning, rinse and dry

thoroughly. Do not use abrasive powders or corrosive

substances.

• Ideally, the inside of the oven should be cleaned after

each use, when it is still lukewarm. Use hot water and

detergent, rinse and dry with a soft cloth. Do not use

abrasive products.

• All accessories - with the exception of the sliding racks

- can be washed like everyday crockery, and are even

dishwasher safe.

! Never use steam cleaners or pressure cleaners on the

appliance.

Cleaning the oven door

Clean the glass part of the oven door using a sponge and

a non-abrasive cleaning product, then dry thoroughly with

a soft cloth. Do not use rough abrasive material or sharp

metal scrapers as these could scratch the surface and

cause the glass to crack.

To clean more thoroughly, you can remove the oven door.

1. Open the oven door fully (

see diagram

2. Lift up and turn the small levers located on the two

hinges (

see diagram

3. Grip the door on the two

external sides and close it

approximately half way. Unlock

the door by pressing on the

clamps

F, then pull the door

towards you lifting it out of its

seat (

see diagram

To replace the door, reverse this

sequence.

Inspecting the seals

Check the door seals around the oven periodically. If the

seals are damaged, please contact your nearest After-

sales Service Centre (

see Assistance

). We recommend

not using the oven until the seals have been replaced.

Replacing the light bulb

To replace the oven light bulb:

1. Remove the glass cover of the lamp-holder.

2. Remove the

light bulb and

replace it with a

similar one:

Wattage 25 W, cap

E 14.

3. Replace the

glass cover (

see

diagram

Sliding Rack Kit Assembly

To assemble the sliding racks:

1. Remove the two

frames, lifting them away

from the spacers “A” (

see

figure

2. Choose which shelf to

use with the sliding rack.

Paying attention to the

direction in which the

sliding rack is to be

extracted, position joint B

and then joint C on the

frame.

3. Secure the two frames

with the guide rails using

the holes provided on the

oven walls (

see diagram

The holes for the left

frame are situated at the

top, while the holes for the

right frame are at the

bottom.

4. Finally, fit the frames on spacer A.

! Do not place the sliding racks in position 5.

Left

guide rail

Right guide

rail

Direction

of extraction

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Hotpoint SH 83 C X Mode d'emploi Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Fours Hotpoint SH 83 C X