Hotpoint RGB506 Manuel d'utilisateur télécharger pdf (Page 26)

INSTALLATION INSTRUCTIONS

(continued)

PROTECT YOUR FLOOR

Your range, like many other household items, is

heavy and can settle into soft floor coverings

such as cushioned vinyl or carpeting. Use care

when moving the range on this type of flooring.

It is recommended that the following simple and

inexpensive instructions be followed to protect

your floor.

The range should be installed on a sheet of plywood

(or similar material). When the floor covering ends

at the front of the range, the area that the range

will rest on should be built up with plywood to

the same level or higher than the floor covering.

This will allow the range to be moved for cleaning

or servicing.

MODEL AND SERIAL NUMBER LOCATION

You’ll find the model and serial numbers on a

label under the lift-up cooktop.

TOOLS YOU WILL NEED

• Phillips and flat-blade screwdrivers

• Pencil and ruler

• Two pipe wrenches (one for backup)

• 1/2

² open-end or adjustable wrench

• Socket wrench (1

⁄

² hex) or channel lock pliers

ADDITIONAL MATERIALS YOU MAY NEED

• Gas line shut-off valve

• Pipe joint sealant or UL-approved pipe thread

tape with Teflon* that resists action of natural

and LP gases

• Flexible metal appliance connector

(1/2² NPT x 3/4² or 1/2² I.D.). Because solid

pipe restricts moving the range, a 4 to 5-foot

length is recommended for ease of installation

but other lengths are acceptable. Never use an

old connector when installing a new range.

• Flare union adapter for connection to gas

supply line (1/2² NPT x 3/4² or 1/2² I.D.).

• Flare union adapter for connection to pressure

regulator on range (1/2² NPT x 3/4² or 1/2² I.D.).

*Teflon: Registered trademark of DuPont

WARNING

All ranges can tip and injury could

result. To prevent accidental tipping

of the range, attach an approved Anti-

Tip device to the wall. (See Installing

the Anti-Tip Device in this section.)

To check if the device is installed and

engaged properly, carefully tip the

range forward. The Anti-Tip device

should engage and prevent the range

from tipping over.

If you pull the range out from the wall for any

reason, make sure the Anti-Tip device is engaged

when you push the range back against the wall.

• For your safety, never use your range for

warming or heating the room. Your oven and

cooktop are not designed to heat your kitchen.

Top burners should not be operated without

cookware on the grate. Such abuse could result

in fire and damage to your range and will void

your warranty.

• Do not store or use combustible materials,

gasoline or other flammable vapors and liquids

in the vicinity of this or any other appliance.

Explosions or fires could result.

• Do not use oven for a storage area. Items

stored in the oven can ignite.

• Do not let cooking grease or other flammable

materials accumulate in or near the range.

GENERAL

• See Dimensions and Clearances in this section

for all rough-in and spacing dimensions. These

dimensions must be met for safe use of your range.

The location of the electrical outlet and pipe opening

(see Gas Pipe and Electric Outlet Locations) may

be adjusted to meet specific requirements.

• The range may be placed with 0² clearance

(flush) at the back wall and side walls of the range.

LOCATION

Do not locate the range where it may be subject

to strong drafts. Any openings in the floor or wall

behind the range should be sealed. Make sure

the openings around the base of the range that

supply fresh air for combustion and ventilation

are not obstructed by carpeting or woodwork.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Hotpoint RGB506 Manuel d'utilisateur Page 26

Commentaires sur ces manuels

Produits connexes et manuels pour Radio Hotpoint RGB506