Hotpoint RGB506 Manuel d'utilisateur télécharger pdf (Page 29)

Usage Situations where Appliance

Power Cord will be Disconnected Infrequently.

An adapter may be used only on a 15-amp circuit.

Do not use an adapter on a 20-amp circuit.

Where local codes permit, a TEMPORARY

CONNECTION may be made to a properly

grounded two-prong wall receptacle by the use

of a UL-listed adapter, available at most hardware

stores. The larger slot in the adapter must be

aligned with the larger slot in the wall receptacle

to provide proper polarity in the connection of

the power cord.

When disconnecting the power cord from the

adapter, always hold the adapter with one hand.

If this is not done, the adapter ground terminal is

very likely to break with repeated use. Should

this happen, DO NOT USE the appliance until a

proper ground has again been established.

CAUTION: Attaching the adapter ground

terminal to the wall receptacle cover screw

does not ground the appliance unless the cover

screw is metal, and not insulated, and the wall

receptacle is grounded through the house

wiring. The customer should have the circuit

checked by a qualified electrician to make sure

the receptacle is properly grounded.

ELECTRICAL CONNECTIONS

(on some models)

Electrical Requirements

120-volt, 60 Hertz, properly grounded branch

circuit protected by a 15-amp or 20-amp circuit

breaker or time delay fuse.

Extension Cord Cautions

Because of potential safety hazards associated

with certain conditions, we strongly recommend

against the use of an extension cord. However,

if you still elect to use an extension cord, it is

absolutely necessary that it be a UL-listed,

3-wire grounding-type appliance extension cord

and that the current carrying rating of the cord

in amperes be equivalent to, or greater than,

the branch circuit rating.

Grounding

IMPORTANT—(Please read carefully)

FOR PERSONAL SAFETY, THIS APPLIANCE

MUST BE PROPERLY GROUNDED.

The power cord of this appliance is equipped

with a three-prong (grounding) plug which

mates with a standard three-prong grounding

wall receptacle

to minimize the

possibility of

electric shock

hazard from

this appliance.

The customer

should have the

wall receptacle

and circuit

checked by a

qualified electrician to make sure the receptacle

is properly grounded.

Where a standard two-prong wall receptacle is

encountered, it is the personal responsibility and

obligation of the customer to have it replaced with

a properly grounded three-prong wall receptacle.

DO NOT, UNDER ANY CIRCUMSTANCES,

CUT OR REMOVE THE THIRD (GROUND)

PRONG FROM THE POWER CORD.

PREFERRED

METHOD

TEMPORARY

METHOD

Ensure proper

ground exists

before use

Ensure proper

ground exists

before use

(Adapter plugs not

permitted in Canada.)

Align large prongs/slots

(continued next page)

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Hotpoint RGB506 Manuel d'utilisateur Page 29

Commentaires sur ces manuels

Produits connexes et manuels pour Radio Hotpoint RGB506