Hotpoint OSX 896 D CX Mode d'emploi télécharger pdf (Page 3)

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

APPLIANCE SPECIFICATIONS

width 43.4 cm

height 39.5 cm

depth 40.8 cm

Volume

70 l

Electrical

connections

voltage: 230 - 240 V~ 50/60 Hz

maximum power absorbed

2600-2800 W (see data plate)

ENERGY

LABEL

Directive 2002/40/EC on the label

of electric ovens.

Standard EN 50304

Declared energy consumption for

Forced convection Class –

heating mode: ECO

This appliance conforms to the

following European Economic

Community directives:

2006/95/EEC dated 12/12/06 (Low

Voltage) and subsequent amendments

– 2004/108/EEC dated 15/12/04 and

subsequent amendments

- 93/68/EEC dated 22/07/93 and

subsequent amendments

- 2002/96/EC and subsequent

amendments.

1275/2008 Standby/off mode

Electrical connection

The electrical connection to the mains must be made

on the appliance. The power voltage and frequency

are as indicated on the rating plate.

THIS APPLIANCE MUST BE EARTHED.THIS APPLIANCE MUST BE EARTHED.

THIS APPLIANCE MUST BE EARTHED.

Connecting the power supply cable

To open the terminal board:

• Using a screwdriver, press on the tabs situated

on each side of the terminal board cover.

• Pull open the terminal board cover.

To connect the power supply cable, proceed as

follows:

• Unscrew the cable clamp screw and the contact

screws L-N-6.

• Fasten the wires beneath the screwheads using

the following colour scheme: Blue (N) Brown (L)

Yellow-Green 6

• Fasten the power supply cable in the

corresponding cable clamp and close the cover.

Electrical Connection:

Voltage Frequency: 230

V-1+N 50Hz

Fuse Section: 16A

Supply cable:

3x1.5mm

You can connect your oven to the system means of

a terminal board. Refer to above information for the

minimal cable sections and the calibration of the

protective elements according to the connection.

If the appliance is installed with a junction box, an

omnipolar circuit breaker - with a minimum contact

opening of 3mm - should be installed between the

appliance and the mains.

Power cable supply connection to the electrical

mains:

We recommend you use a power supply cable which

is long enough to allow you to take the oven out of

its recess in the event of maintenance operations

(only use HAR - H 05 - RRF quality cables fitted with

a plug conforming to the regulations in force.

The plug must be accessible at all times.

Unplug the appliance before all operations, even

when replacing the oven lamp.

Using the appliance without correct earthing is

highly dangerous.

! After connecting the appliance to the flexible

cable, tighten all the screws on the terminal

board.

1 2 3 4 5 6 7 8 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Hotpoint OSX 896 D CX Mode d'emploi Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Non Hotpoint OSX 896 D CX