Hotpoint SX 1049L CX S Mode d'emploi télécharger pdf (Page 6)

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

Electrical Connection

The electrical connection to the mains must be made on

the appliance. The power voltage and frequency are as

indicated on the rating plate.

! THIS APPLIANCE MUST BE EARTHED.

Fitting the power supply cable

1. Open the terminal board

by inserting a screwdriver

into the side tabs of the

cover. Use the screwdriver

as a lever by pushing it

down to open the cover (see

diagram)

2. Install the power supply

cable by loosening the

cable clamp screw and the

three wire contact screws

L-N-

Connect the wires to the

corresponding terminals:

the Blue wire to the terminal

marked (N), the Brown wire

to the terminal marked (L)

and the Yellow/Green wire

to the terminal marked

(see diagram).

3. Secure the cable by fastening the clamp screw.

4. Close the cover of the terminal board.

Electrical Connection:

Voltage Frequency: see data plate

Fuse Section: 16A

Supply cable: 3x1.5mm

You can connect your oven to the system means of a

terminal board. Refer to above information for the minimal

cable sections and the calibration of the protective elements

according to the connection.

If the appliance is installed with a junction box, an

omnipolar circuit breaker - with a minimum contact

opening of 3mm - should be installed between the appliance

and the mains.

Power cable supply connection to the electrical mains:

We recommend you use a power supply cable which is

long enough to allow you to take the oven out of its recess

in the event of maintenance operations (only use HAR - H

05 - RRF quality cables tted with a plug conforming to the

regulations in force.

The plug must be accessible at all times.

Unplug the appliance before all operations, even

when replacing the oven lamp.

Using the appliance without correct earthing is highly

dangerous.

! After connecting the appliance to the exible cable,

tighten all the screws on the terminal board.

APPLIANCE SPECIFICATIONS

Dimensions*

width 43.5 cm

height 32,4 cm

depth 41.5 cm

Volume*

59 l

Dimensions**

width 45.5 cm

height 32,4 cm

depth 41.5 cm

Volume**

62 l

Electrical

connections

voltage: 230-240V~ 50/60Hz or 50Hz

(see data plate)

maximum power absorbed

2800-3000 W

ENERGY

LABEL

Directive 2002/40/EC on the label

of electric ovens. Standard EN 50304

Declared energy consumption

for Forced convection Class –

heating mode:

ECO.

* Only for models with drawn rails.

** Only for models with wire rails.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Hotpoint SX 1049L CX S Mode d'emploi Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Non Hotpoint SX 1049L CX S