Hotpoint HSIC 3T127 C Guide de l'utilisateur télécharger pdf (Page 7)

CLEANING THE FILTER ASSEMBLY

Regularly clean the lter assembly so that the lters do not clog and

that the waste water ows away correctly.

The lter assembly consists of three lters which remove food residues

from the washing water and then recirculate the water: to obtain the

best washing results, you need to keep them clean.

The dishwasher must not be used without lters or if the lter is

loose.

After several washes, check the lter assembly and if necessary clean it

thoroughly under running water, using a non-metallic brush and follo-

wing the instructions below:

1. Turn the cylindrical lter A in an anti-clockwise direction and pull

it out (Fig 1).

2. Remove the cup lter B by exerting a slight pressure on the side

aps(Fig 2).

3. Slide out the stainless-steel plate lter C(Fig 3).

4. Inspect the trap and remove any food residues. NEVER REMOVE

the wash-cycle pump protection (black detail) (Fig 4).

1 2

3 4

After cleaning the lters, re-place the lter assembly and x it in

position correctly; this is essential for maintaining the ecient

operation of the dishwasher.

CLEANING THE SPRAY ARMS

On occasions, food residue may become encrusted onto the spray

arms and block the holes used to spray the water. It is therefore recom-

mended that you check the arms from time to time and clean them

with a small non-metallic brush.

To remove the upper spray arm, turn the plastic locking ring in an an-

ti-clockwise direction. The upper spray arm should be replaced so that

the side with the greater number of holes is facing upwards.

The lower spray arm may be removed by pulling it upwards.

CLEANING THE WATER INLET HOSE

If the water hoses are new or have not been used for an extended

period of time, let the water run to make sure it is clear and free of

impurities before performing the necessary connections. If this

precaution is not taken, the water inlet could become blocked and da-

mage the dishwasher.

CARE AND MAINTENANCE

1 2 3 4 5 6 7 8

Pas de commentaire

Hotpoint HSIC 3T127 C Guide de l'utilisateur Page 7