Hotpoint LFF 825 X AUS.R Mode d'emploi télécharger pdf (Page 6)

Start-up and use

Starting the dishwasher

1. Turn the water tap on.

2. Press the ON/OFF button: you will hear a short beep; all the

indicator lights and the display will light up for a few seconds.

3. Open the door and pour in a suitable amount of detergent

(see below).

4. Load the racks (see Loading the racks) and shut the door.

5. Select the wash cycle in accordance with the type of

crockery and its soil level (see Table of wash cycles) by

pressing the P button.

6. Select the wash options* (see adjacent information).

7. Start the cycle by pressing the Start/Pause button: a long

beep signals the start of the wash cycle, the washing cycle

indicator light switches on and the time remaining until the end

of the cycle is displayed.

8. Two short beeps and one long one indicate the end of the

wash cycle; the wash cycle indicator light flashes and the END

indicator light switches on (fixed light). Switch off the appliance

by pressing the ON/OFF button, shut off the water valve and

unplug the appliance from the electricity socket.

9. Wait for a few minutes before removing the crockery, in

order to avoid burns. Unload the racks, beginning with the

lower level.

AUTO WASH CYCLES

*: this model of dishwasher is

equipped with a special sensor which can be used to assess

the level of soiling and automatically select the most efficient

and economic wash cycle accordingly.

The duration of the auto wash cycles may vary due to the

operation of the sensor.

Modifying a wash cycle in progress

If a mistake was made during the wash cycle selection

process it is possible to change the cycle, provided that it has

only just begun: once the wash cycle has started, switch off

the machine by pressing and holding the ON/OFF/Reset

button. Switch it back on using the same button and select the

desired wash cycle and options.

Adding extra crockery

Press the Start/Pause button (the corresponding indicator light

will flash). Open the door, taking care to avoid the escaping

steam, and place the crockery inside the appliance. Press the

Start/Pause button (fixed light): the cycle will restart after a

prolonged beep is emitted.

If the Start/Pause button is pressed so as to pause the

machine, the wash cycle or the Delayed Start

* function (if

selected) is interrupted.

At this stage it is not possible to change the wash cycle.

Accidental interruptions

If the door is opened during the wash cycle, or if there is a

power cut, the cycle stops. It starts again from the point at

which it was interrupted once the door has been shut or once

the electricity supply is restored.

Measuring out the detergent

Dishwasher detergents are strongly alkaline.

They can be extremely dangerous if swallowed.

Avoid contact with the skin and eyes and keep

children away from the dishwasher when the

door is open. Check that the detergent receptacle

is empty after completion of the wash cycle.

A good wash result also depends on the

correct amount of detergent being used;

exceeding the stated amount does not result in a

more effective wash and increases environmental

pollution.

Only use detergent which has been

specifically designed for dishwashers.

 DO NOT USE washing up liquid.

Using excessive detergent may result in foam

residue remaining in the machine after the cycle

has ended.

To achieve the best results from each washing

and drying cycle, powder detergent, rinse aid

liquid and salt should be used.

Compartment A: Washing detergent

Compartment B: Pre-wash detergent

1. Open cover C by pressing button

2. Pour in the detergent after

consulting the Table of wash cycles:

 For powder detergent use

compartments A and B.

 For detergent in tablet form: when

the cycle requires 1 tablet, place it

in compartment A and close the

cover; when it requires 2, place the second tablet at the

bottom of the appliance.

3. Remove detergent residues from the edges of the

compartment and close the cover until it clicks.

* Only available in selected models.

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

Hotpoint LFF 825 X AUS.R Mode d'emploi Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle Hotpoint LFF 825 X AUS.R