Hotpoint WFE 2B19 X SA Guide de l'utilisateur Page 4

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 8
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 3
4
OPTIONS AND FUNCTIONS
OPTIONS can be selected directly by pressing the corresponding
button (see CONTROL PANEL).
HALF LOAD
If there are not many dishes to be washed, a half load
cycle may be used in order to save water, electricity and
detergent. Select the program and press the HALF LOAD
button: the indicator light will light up. Press the HALF
LOAD button to deselect this option.
Remember to halve the amount of detergent.
TABLET (Tab)
This setting allows you to optimize the performance of
the program according to the type of detergent used.
Press the TABLET button (the indicator light will light up)
if you use combined detergents in tablet form (rinse aid,
salt and detergent in 1 dose).
If you use powder or liquid detergent, this option
should be off.
DELAY
It is possible to delay the start time of the program by 2, 4
or 8 hours:
1.After selecting the desired program and any other
options, press the DELAY button. The indicator light will
go on.
2.Select the desired delay time by pressing the DELAY
button repeatedly. The 2 hours, 4 hours and 8 hours
indicator lights will go on in succession. If the DELAY
button is pressed again, the option is deselected and the
indicator light goes off.
3.After the selection process, the countdown will begin if
the START/PAUSE button is pressed. The selected delay-
period indicator light is on and the Start/Pause button
lights up (fixed light).
4.Once this time has elapsed, the DELAY indicator light
goes off and the program begins.
The DELAY function cannot be set once a program has
started.
DRAIN OUT
To stop and cancel the active cycle, the Drain Out
function can be used.
A long press of START/PAUSE button, will activate the
DRAIN OUT function. The active program will be stopped
and the water in the dishwasher will be drained out.
If an option is not compatible with the selected program see
PROGRAMS TABLE, the corresponding LED flashes rapidly 3 times
and beeps will sound. The option will not be enabled.
Vue de la page 3
1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire