Hotpoint RFA52T (0) Mode d'emploi télécharger pdf (Page 3)

8. Never clean the appliance or perform maintenance without

first disconnecting it from the electrical mains. Turning the

thermostat knob to the setting does not suffice to break

all electrical contact with the mains.

9. Before having your old refrigerator picked up for disposal,

remove or make inoperable any locking devices to prevent

children who might play in or around the appliance from

being locked inside.

10. Before calling for service/assistance in the case of mal-

function, consult the chapter entitled “TROUBLESHOOTING"

to determine whether it is possible to eliminate the problem.

Do not try to repair the problem by trying to access the inter-

nal components of the appliance.

11. If damaged, the power supply cord on this appliance

must necessarily be replaced by our service centre because

special tools are required for replacement.

12. Do not use electric appliances inside the compartment

for food storage, if these are not those recommended by the

manufacturer.

13. At the end of the functional life of your appliance –

containing cyclopentane gas in the insulation foam and

perhaps gas R600a (isobutane) in the refrigeration circuit –

the latter should made safe before being sent to the dump.

For this operation, please contact your dealer or the Local

Organisation in charge of waste disposal.

cordance with safety standards for 46/90 systems. If the socket

is not fitted with an earthing wire, the manufacturer will not

be held liable for any damages and/or injuries arising out of

the use of the appliance. Do not use multiple sockets or

adapters.

Position the appliance in such a way that you can access

the socket where it is plugged in.

Insufficient power?

The electrical socket must be able to handle the maximum

power load of the appliance, which is indicated on the rating

plate located within the freezer.

Before making the electrical connection ...

After the appliance has been delivered, place it in the verti-

cal upright position and wait at least 3 hours before inserting

the plug into the socket in order to ensure that it functions

properly.

ATTENTION

Read your manual carefully since it contains instructions which

will ensure safe installation, use and maintenance of your

appliance.

Your Refrigerator is built to International safety standards

(EN60) and has been awarded the European approval mark

(IMQ) for compliance with UK electrical safety requirements.

It also meets the EC standards on the prevention and elimi-

nation of radio interference (EC directive 87/308 - 02.06.89).

PRODUCT SAFETY

1. This appliance must not be installed outdoors - not even in

an area protected by a roof. It is extremely dangerous to

leave it exposed to rain or storms.

2. It must only be used by adults and exclusively to refriger-

ate and freeze foodstuffs, following the instructions for use

contained in this manual.

3. Do not ever touch or handle the appliance with bare feet

or with wet hands or feet.

4. It is highly recommended that you do not use extension

cords or multiple socket adapters. If the refrigerator is in-

stalled between cabinets, make sure that the cord is not

bent or dangerously pinched or compressed.

5. Never pull on the cord or the refrigerator to remove the

plug from the wall socket - this is very dangerous.

6. Never touch the cooling components within the appliance,

especially with wet hands because this could result in injury.

7. Never put ice cubes just removed from the freezer into

your mouth because they could stick to your mouth and cause

burns.

INSTALLATION

To ensure that the appliance operates properly and to reduce

energy consumption, it is important that the appliance is in-

stalled correctly.

Ventilation

The compressor and condenser generate heat and, therefore,

need to be ventilated properly. Areas not adequately ventilated

are not suitable for this appliance. Therefore it should be

installed in a room with an opening (eg. window) that provides

the appropriate amount of air re-circulation. It is also important

that the room is not too humid.

Away from Heat

Avoid positioning the appliance in a place where it is directly

exposed to sunlight or near an oven, hob or the like.

Electrical Connection and Earthing

Before proceeding with the electrical connection, make sure

that the voltage indicated on the rating plate, located within

the freezer, corresponds to the mains voltage in your homeand

that the socket is fitted with a standard earthing wire in ac-

1 2 3 4 5 6 7 8 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

Hotpoint RFA52T (0) Mode d'emploi Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Congélateurs Hotpoint RFA52T (0)