Hotpoint GQ64ST Manuel d'utilisateur télécharger pdf (Page 7)

Installation

The following instructions are intended for the installer so that

the installation and maintenance procedures may be followed in

the most professional and expert manner possible. Important:

Disconnect the appliance from the electrical supply before

performing any maintenance or repair.

This manual is for a class 3 built-in cooktop.

Positioning the Cooktop

Important: this unit may be installed and used only in permanently

ventilated rooms in accordance with British Standard Codes Of

Practice: B.S. 6172 / B.S. 5440, Par. 2 and B.S. 6891 Current

Editions. The following requirements must be observed:

a) The room must be fitted with a ventilation system which

vents smoke and gases from combustion to the outside.

This must be done by means of a hood or electric ventilator

that turns on automatically each time the hob is operated.

In a chimney stack or branched flue. Directly to the Outside

(exclusively for cooking appliances)

b) The room must have an air flow to allow for proper combustion.

This must be 2 m

³/h per kW of installed power. The airflow

can be created using an enclosed vent with an inner cross

section of at least 100 cm² which must not be able to be

blocked. If the appliance does not have a flame failure device,

the vent must have an internal cross section of 200 cm

(Fig. A). Alternatively the room in which the hob is situated

can be vented indirectly through ventilation ducts as specified

above, as long as the adjacent room is not a shared area, a

bedroom or present any risk of fire (Fig. B).

Detail A Adjacent Room to be

Room Vented

Examples of ventilation holes Enlarging the ventilation slot

for comburant air. between window and floor.

Fig. A Fig. B

c) Intensive and prolonged use of the appliance may necessi-

tate supplemental ventilation, e.g. opening a window or

increasing the power of the air intake system (if present).

d) Liquidified petroleum gases are heavier than air and, as a

result, settle downwards. Rooms in which LPG tanks are

installed must be fitted with ventilation openings to the outside

in order to allow the gas to escape in the event of a leak.

Therefore, LPG tanks, whether empty or partially full, must

not be installed or stored in rooms or spaces below ground

level (cellars, ect.). It is also a good idea to keep only the

tank currently being used in the room, making sure that it is

not near sources of heat (ovens, fireplaces, stoves, etc.)

that could raise the internal temperature of the tank above

50°C.

Installation of Built-in Hobs

The gas hob is equipped with type X degree protection against

overheating. Therefore, the appliance can be installed next to

cabinets, provided the height of the cabinet does not exceed

that of the hob. For proper installation of the hob, the following

guidlines must be followed:

a) If the cabinet(s) located next to the hob are higher than the

hob itself, the cabinet(s) must be installed at least 110 mm

from the hob edge.

b) Hoods must be installed in accordance with the instructions

contained in the installation manual for the hoods themselves,

and no less than 650 mm from the hob.

c) In the case of the 600 mm cooker hoods, besides following

the recommendations in point b), the cabinets should be

positioned next to the hood at a height of at least 540 mm

from the top since this will make it possible to install the lid

and move it correctly. The cabinet should always be installed

at a height from the top which allows easy use of pots and

pans on the cooker.

d) Should the hob be installed directly under a cupboard, the

latter should be at least 700 mm (millimetres) from the top,

as shown in Figure.

600mm min.

540mm min.

700mm min.

e) The dimensions of the cutout for the appliance must be those

indicated in the figure. Clamps are provided to fasten the hob

to counters measuring from 20 to 40 mm in thickness. To

fasten the hob securely, it is recommended that all the clamps

be used.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

Hotpoint GQ64ST Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Plaques chauffantes Hotpoint GQ64ST