Hotpoint SE1002X Manuel d'utilisateur télécharger pdf (Page 12)

Inspecting the seals

Check the door seals around the oven periodically. If

the seals are damaged, please contact your nearest

After-sales Service Centre (see Assistance). We

recommend not using the oven until the seals have

been replaced.

Replacing the light bulb

To replace the oven light bulb:

1. Remove the glass cover of the lamp-holder.

2. Remove the light bulb and replace it with a similar

one: halogen lamp voltage 230V, wattage 25 W, cap

G 9.

3. Replace the glass cover (see diagram).

! Do not touch the light bulb directly with your hands.

Warning:

The appliance is fitted with an automatic diagnostic

system which detects any malfunctions. Malfunctions

are displayed by messages of the type: ER followed

by numbers.

Call for technical assistance should a malfunction

occur.

Switching the appliance off

Disconnect your appliance from the electricity supply

before carrying out any work on it.

Cleaning the appliance

 The stainless-steel or enamel-coated external parts

as well as the rubber seals may be cleaned using a

sponge that has been soaked in lukewarm water

and neutral soap. If these stains are difficult to

remove, use only specialised products. After

cleaning, rinse and dry thoroughly. Do not use

abrasive powders or corrosive substances.

 Ideally, the inside of the oven should be cleaned

after each use, when it is still lukewarm. Use hot

water and detergent, rinse and dry with a soft cloth.

Do not use abrasive products.

 The accessories can be washed like everyday

crockery (even in your dishwasher).

Cleaning the oven door

Clean the glass door using non-abrasive products and

sponges and dry it with a soft cloth.

To clean more thoroughly, you can remove the oven

door.

1. Open the oven door fully

(see diagram)

2. Lift up and turn the small

levers located on the two

hinges (see diagram)

3. Grip the door on the two

external sides and close it

approximately half way. Unlock

the door by pressing on the

clamps F, then pull the door

towards you lifting it out of its

seat (see diagram). To replace

the door, reverse this

sequence.

Maintenance and care

1 2 ... 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Hotpoint SE1002X Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Four Hotpoint SE1002X