Hotpoint DSD60S Mode d'emploi télécharger pdf (Page 11)

The hotplate lid is fitted with a safety device which

cuts off the gas supply to the hotplate burners

unless the lid is fully open. Do not use the safety

device as a means of controlling the hotplate

burners.

The hotplate has two high speed burners and two

simmering burners which will accommodate pans

between 100mm (4") and 240mm (91/2") diameter.

All pans should be positioned centrally over the

burners.

TO USE THE HOTPLATE

1. Remove any items or spillage from the top of the

lid and then raise it to its fully open position.

2. Push in and turn the control knob of the chosen

burner anti-clockwise to the large flame symbol.

Continue to press the ignition button* until the sparks

light the gas.

3. Turn the control knob anti-clockwise to reduce the

heat input. Only turn the control knob between the

large flame symbol and the small flame symbol

when adjusting the setting.

4. To turn off, turn the control knob fully clockwise to

the symbol O.

DO NOT use the hotplate unless all pan supports

are in position.

DO NOT use mis-shapen pans which may be

unstable.

DO NOT use round base woks directly on the pan

supports.

DO NOT use the glass lid as a working surface.

Each burner is fitted with a spark ignitor for lighting

the gas. To ensure rapid lighting of the burners

every time they are used, the ignitors must be kept

clean and dry. Remove any food spillage or

cleaning materials from the ignitor using a small

nylon brush such as a tooth brush. Access to the

ignitor can be achieved by lifting off the loose burner

parts carefully when the burners are cool.

When the hotplate burner bodies and caps are

removed for cleaning, be careful not to drop any

food particles or cleaning materials into the burner

bases, to avoid the possibility of blocking the gas

jets.

If aluminium based pans are used, a silvery deposit

may appear on the top edge of the pan support

fingers. See 'Care and Cleaning' section for cleaning

information.

SAFETY REQUIREMENTS FOR DEEP FAT FRYING

1. Never fill chip pans more than one third full with oil

or fat.

2. Never leave oil or fat unattended during the heating

or cooling period.

3. Never heat fat or fry with a lid on the pan.

4. Always dry food thoroughly before frying, and lower

it slowly into the hot oil or fat. Frozen foods in

particular will cause frothing and spitting if added

too quickly.

5. Always keep the outside of the pan clean and free

from streaks of oil or fat.

HOW TO DEAL WITH A FAT FIRE

1. Do not move the pan.

2. Turn off the hotplate burners.

3. Smother the flames with a fire blanket or damp cloth

to extinguish the fire. Do not use water or a fire

extinguisher as the force of it may spread the

burning fat or oil over the edge of the pan.

4. Leave the pan for at least 60 minutes before moving

it.

Models with Hob Gas Burner Safety Devices to

Prevent Leaks

These models

can be identified

by the presence

of the device

itself.

! Since the hob

burners are

equipped with a

safety device,

you must hold the control knob in for about 3-7

seconds after the burner has been lighted to allow

the gas to pass until the safety thermocouple has

heated.

HOB GAS BURNER

SAFETY DEVICE

ELECTRONIC

LIGHTING DEVICE

Hotplate

*Available only in certain models.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Hotpoint DSD60S Mode d'emploi Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Micro-ondes Hotpoint DSD60S