Hotpoint MWH211 Manuel d'utilisateur Page 2

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 23
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 1
2
WARNING - THIS APPLIANCE MUST BE
EARTHED
IMPORTANT
The wires in the mains lead are coloured in
accordance with the following code:
Green and yellow: Earth
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead
may not correspond with the coloured markings
identifying the terminals in your plug, proceed
as follows:
The green and yellow wire must be connected to
the terminal in the plug marked with the letter E
or the earth symbol or coloured green or
green and yellow.
The blue wire must be connected to the terminal
marked with the letter N or coloured black.
The brown wire must be connected to the
terminal marked with the letter L or coloured
red.
N
E
L
A) If your appliance comes fitted with a plug, it
will incorporate a 13 Amp fuse. If it does not
fit your socket, the plug should be cut off
from the mains lead, and an appropriate
plug fitted, as below.
WARNING: Very carefully dispose of the cut
off plug after removing the fuse: do not
insert in a 13 Amp socket elsewhere in the
house as this could cause a shock hazard.
With alternative plugs not incorporating a
fuse, the circuit must be protected by a 15
Amp fuse.
If the plug is a moulded-on type, the fuse
cover must be re-fitted when changing the
fuse using a 13 Amp Asta approved fuse to
BS 1362. In the event of losing the fuse
cover, the plug must NOT be used until a
replacement fuse cover can be obtained
from your nearest electrical dealer. The
colour of the correct replacement fuse cover
is that as marked on the base of the plug.
B) If your appliance is not fitted with a plug,
please follow the instructions provided
below:
ELECTRICAL CONNECTION
Data and instruction for Performance Tests according to IEC 60705 and EN 60705 (19999-04)
The International Electrotechnical Commission SC 59H, has developed a Standard for comparative testing of heating performances
of microwave ovens.
We recommend the following for this oven:
Test Nr.
on
standard
Item
Power
level
Weight
Standing
time
12.3.1
750 gr
12.3.2
475 gr
12.3.3
900 gr
500 gr
900w
output power
Duration
Function
Note
Egg
custard
14’ - 16’
6’ - 7’
18’ - 20’
6’ - 8’
Sponge
cake
Meat
loaf
Defrosting
minced
meat
only
MW
only
MW
only
MW
5 min.
5 min.
5 min.
15 min.
The upper surface shall be evaluated after the
standing time. The inner custard evaluation shall
be conducted after two hours.
Use the borosilicate glass container stated in the
Standard (max dia. 210 mm) or a Pyrex® glass
container dia. 210 mm, height 50 mm and wall
thick. 6mm.
Cover the container with cling film and pierce the
film. Use the rectangular borosilicate glass container
stated in the Standard or the Arcopal® Cat. nr
Z1/B8 (01)10460-1
Place the frozen load directly on the turnable (D).
Turn upsidedown the load after half of the
defrosting time.
only
MW
700w
output power
Duration
18’ - 20’
8’ - 9’
22’ - 24’
9’ - 11’
13.3
Vue de la page 1
1 2 3 4 5 6 7 ... 22 23

Commentaires sur ces manuels

Pas de commentaire