Hotpoint AKP 503/NB/02 Mode d'emploi télécharger pdf (Page 10)

N C

M Y

INSTALLATION

General hints

y This appliance must be installed by a

competent electrican, with all electrical and

installation requirements prescribed by local

regulations and manufacturer instructions.

y The furniture in contact with the oven must

be heat- resistant (80

o

C).

y Remove any packaging material from inside

the oven.

y Leave the oven to stand on its

polystyrene packaging base to avoid

damaging the oven bottom.

BUILDING-IN

y Do not lift the oven by the door handle,

but lift it at the sides as illustrated (see

arrow).

y The oven has been designed for building-in

in a column.

y The oven and housing dimensions are

illustrated in opposite figure.

y To ensure a correct ventilation, respect the

ventilation gaps shown in opposite figure.

y Install the oven in the housing, lifting it at

the sides, taking care not to trap the wires

of the electrical supply cable.

y Fix the oven to the housing tightening the

screws (E) and (F) as illustrated.

ATTENTION

y Prior to any intervention, disconnect the oven

from the mains supply.

y After installation, electric parts must not be

accessible.

A multiple circuit breaker with a space between

the contacts of 3 mm or more must be fitted.

(LS switches, fuses, relays).

The technician is responsible for the correct

installation of the appliance and of its

compliance with local regulations.

y The earthing of this appliance is

compulsory by law: forthisreasonall

current and earth conductors must be of an

appropriate size.

Note:

To allow for proper ventilation, we recommend

that you left two openings of min. 500x80 mm

and 500x50 mm inside the cabinet (see

drawing).

89

1 2 ... 5 6 7 8 9 10 11

Commentaires sur ces manuels

Pas de commentaire